Bulldog Security TR25 User manual

TR25
Quick Start Guide
The TR25 can be directly connected to a vehicle with a power output
of 12 - 24V.
Connect the BLACK wire to the battery negative, chassis or other
ground point.
Connect the RED wire to the battery positive or other un-switched
positive wire.
If replacing an existing 2 wire GPS tracker, simply cut the black and
red wires of the existing tracker, one at a time, and use the supplied
connector block to attach the corresponding black and red wires
from the TR25. Take care not to touch the wires together.
Do not mount the TR25 in the engine bay or other area where it can
get wet; next to radio equipment; between metal cavities in the
vehicle or other parts of the vehicle where interference may be
caused such as radio speakers. These instructions are for a negative
earth vehicle..
INSTALLATION
Your TR25 has a SIM card inserted in it and you will need to register
this SIM card and your tracker to allow you to use it.
To register please visit:
www.bulldogtracking.co.uk/register
During the registration you will need your SIM Serial Card Number
and the Tracker IMEI Number. These can be found on the last page
of these instructions.
Once registration is conrmed, your TR25 tracker can be tracked via
smartphone app or website.
Smartphone app: Visit your app store, search and download GPS
Tracker MS03. Enter the User Account and Password as chosen..
Website: Visit http://track.bulldogtracking.co.uk Use the same log in
details as the smartphone app.. Use the smartphone app for all
tracking on a phone or tablet.
REGISTER & TRACK
BULLDOG SHALL IN NO EVENT BE LIABLE FOR ANY SPECIAL, INDIRECT, INCIDENTAL,
CONSEQUENTIAL OR PUNITIVE DAMAGES OR FOR LOSS, DAMAGE, OR EXPENSE,
INCLUDING LOSS OF USE, PROFITS, REVENUE, OR GOODWILL, DIRECTLY OR INDIRECTLY
ARISING FROM PURCHASER’S USE OR INABILITY TO USE THE PRODUCT, OR FOR LOSS OR
DESTRUCTION OF OTHER PROPERTY OR FROM ANY OTHER CAUSE, EVEN IF BULLDOG
HAS BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGE. BULLDOG SHALL HAVE NO
LIABILITY FOR ANY DEATH, PERSONAL AND/OR BODILY INJURY AND/OR DAMAGE TO
PROPERTY OR OTHER LOSS WHETHER DIRECT, INDIRECT, INCIDENTAL CONSEQUENTIAL
OR OTHERWISE, BASED ON A CLAIM THAT THE PRODUCT FAILED TO FUNCTION.
THE TRACKING SERVICE ASSOCIATED WITH THE TR25 IS PROVIDED BY A THIRD PARTY
AND AS SUCH BULLDOG SHALL IN NO EVENT BE LIABLE FOR THE SERVICE PROVIDED
INCLUDING, BUT NOT LIMITED TO, THE AVAILABILITY, ACCURACY, FUNCTIONALITY OR
SUITABLIBITY AND MAY BE WITHDRAWN AT ANY TIME, WITHOUT NOTICE.
THE SIM CARD INSTALLED IN THE TR25 IS PROVIDED BY A THIRD PARTY AND AS SUCH
BULLDOG SHALL IN NO EVENT BE LIABLE FOR THE SERVICE PROVIDED INCLUDING, BUT
NOT LIMITED TO, NETWORK AVAILABILITY, FUNCTIONALITY OR SUITABLIBITY AND MAY
BE WITHDRAWN AT ANY TIME, WITHOUT NOTICE. USE OF THE SIM CARD IN THE TR25 IS
SUBJECT TO THE TERMS AND CONDITIONS OF THE PROVIDER, GPS|SIMCARD, AND SUCH
TERMS CAN BE VIEWED AT GPSSIMCARD.CO.UK/TERMS . THE SIM CARD IN THE TR25
REQUIRES REGISTRATION AND DETAILS ARE PROVIDED AT
WWW.BULLDOGTRACKING.CO.UK/REGISTER
Bulldog Security Products Ltd, Units 1-4 Stretton Road. Much Wenlock.
Shropshire. TF13 6DH
Customer Service:
01952 728171
www.bulldogtracking.co.uk

Upon logging in, the app will show the location of the tracker.
To set a speed alert to notify you if the tracker moves, press the
menu icon:
Fig 1. Press Management
Fig 2. Select Set the speeding alarm
Fig 3. In the Speed Limit box enter a speed (in km/h) over which
you want to receive a push notication in the event of this speed
being exceeded. Press the Tick in the top right corner.
Fig 4. If the command is successful a success message will be
displayed - Send successfully
When your tracked asset exceeds the set speed limit, a push
notication will be shown on your smartphone
To disable the speed alert, proceed as above but in the Speed
Limit box, enter 0
If you receive an error message such as Tracker Oine, try again
later.
SET UP SPEED ALERT
PUSH NOTIFICATIONS
To receive push notications, you must ensure that they are enabled
in your tracking app.
To set a speed alert to notify you if the tracker moves, press the menu
icon:
Fig 5. Press Settings
Fig 6. Push notication
Fig 7. Tap the slider on Push notications (7a), select All (7b), then
press the Tick (7c)
Please test the push notications by exceeding the preset speed limit
and ensure the push notication is triggered. If not ensure that the
MS03 app is permitted to send push notications within your iOS or
Android setting
Fig. 1 Fig. 2 Fig. 3
Fig. 4
7c
7a
7b
Fig. 5 Fig. 6 Fig. 7
Whilst changing settings in the screen shown in Fig 6. ensure that
the following are set:
Distance Unit: Mile
GPS Invalid: Show last GPS location