Preparation
1. To get the fire started, you will need material that can be readily ignited or kindling
and you will need firewood to fuel the fire.
2. Gather these materials before attempting to light the fire so you are prepared.
3. If the available firewood is too large, cut, trim or split the firewood to fit in the fire
pit without overhang.
4. Don’t overload the fire pit. As a general rule, the maximum fuel load is half the area
provided for the fire to burn. In a firebox, this means you cannot fill the box above
half. In a fire bowl, this means you cannot fill the bowl more than half the diameter of
the bowl.
5. Don’t arrange the fuel in tight bunches. Allow space between the firewood pieces to
ensure good air movement in the fire.
Lighting
1. Place a layer of dry kindling such as sticks or twigs. You can also use firelighters.
2. Place a small amount of firewood directly above the kindling.
3. Use a long match or a gas lighter to light the kindling.
Maintaining the Fire
l Wear oven mitts or protective gloves when tending to the fire.
l After the fire has been established, add more firewood directly on top of the fire as
desired but do this gradually to avoid overloading.
l Use a poker to reposition coals and improve airflow as desired.
l Never pour Petrol, Kerosene, Diesel, lighter fluid or alcohol onto the firepit.
Extinguishing
Allow the fire to burn out. Do not douse the fire with water, the sudden temperature change
can cause immediate damage to the fire pit.
Page 7
OPERATING INSTRUCTIONS
