Burnside 292-WF-STR User manual

ASSEMBLY INSTRUCTIONS
W-FRAME STARTER
// 292-WF-STR
Use to build a stand-alone Burnside
wall system.

ASSEMBLY INSTRUCTIONS
GRAND + BENEDICTS | 800.547.7005 |www.grand-benedicts.com
W-FRAME STARTER
PARTS LIST:
1. End Frame - Left - (1)
2. End Frame - Right - (1)
3. Top & Bottom Rail - (2)
4. Upright Center - (1)
5. Upright Sides - (2)
6. Joint Connector Single - (6)
7. 3/8”-16 TPI Leveler - (4)
8. Socket Countersink Head Screw
1/4”-20 X 0.625”
9. SBHC SCREW #10 - 24 X 0.375” - (24)
10. Joint Connector Bolt
1/4”-20 X 0.625” (6)
11. HEX NUT 1/4” - 20 TPI (6)
12. Allen Wrench
10
11
7
1
3
4
5
2
3
12
6
8
9

ASSEMBLY INSTRUCTIONS
GRAND + BENEDICTS | 800.547.7005 |www.grand-benedicts.com
W-FRAME STARTER
STEP ONE:
Attach Upright Sides to Top & Bot-
tom Rails using the Countersink Head
Screws with Allen Wrench.
STEP TWO:
Attach Levelers.
UPRIGHT SIDE
BOTTOM RAIL
TOP RAIL
COMPLETED
COUNTERSINK HEAD SCREW
1/4” - 20 X 0.625”

ASSEMBLY INSTRUCTIONS
GRAND + BENEDICTS | 800.547.7005 |www.grand-benedicts.com
W-FRAME STARTER
STEP THREE:
Attach the Upright Sides & Upright
Center with the Joint Connectors using
the Joint Connector Bolts & Hex Nuts
with the Allen Wrench.
FIXTURE IS COMPLETE
NOTE: The Upright Center has holes on
either side while the Upright Sides will
only have holes on the inside of
the frame.
JOINT CONNECTOR BOLT
1/4” - 20 X 0.625”
HEX NUT
1/4” - 20 TPI
ALIGN CONNECTORS OVER
THE SCORED LINES ON TOP & BOTTOM
ALIGN CONNECTORS OVER
THE SCORED LINES ON TOP & BOTTOM
COMPLETED
FIXTURE