ASSEMBLY INSTRUCTIONS
GRAND + BENEDICTS | 800.547.7005 |www.grand-benedicts.com
UPRIGHT
Please note that wall mounting screws
are not included and it’s the responsibil-
ity of the installer to select appropriate
hardware. For accuracy and efficiency, we
recommend that you use a Laser Leveler
and professional installers for this job.
STEP 1: Before you start, determine what
height you need to mount the wall mount-
ing brackets. The uprights are supposed
to be resting on the floor (not floating).
The levelers have a few inches of play and
can be used to even out an uneven floor.
STEP 2: Measure the wall and establish
a starting point and two horizontal, level
lines. Mark the the lines 24” on center.
STEP 3:Mount the two wall brackets for
the first upright on a vertically level line
78” on center.
STEP 4:Attach the upright to the wall
brackets with the screws provided. Adjust
levelers as needed.
STEP 5: Mount the second set of wall
brackets 24” on center and attach upright.
Before moving on, use a Burnside shelf
or a hangbar to test and ensure correct
spacing.
SCREWS X 4
11.5”
24” ON CENTER
OR 48” ON CENTER
24” ON CENTER
OR 48” ON CENTER
NOTE: CAN USE HANGBARS 292-HB24-1-5
OR 292-HB48-1-5 AS SPACER
LEVELER
78” ON CENTER
(78”on center is from bottom hole to bottom hole)
WALL BRACKETS X2
(can be turned vertical or horizontal)
(11.5” from bottom of upright to
center of bottom bracket hole)
