BushBaby BBSBottle User manual

1 Version 2.1
Bush Baby Stealth Bottle
Camera Manual
SKU: BBSBottle

2 Version 2.1
THANK YOU FOR PURCHASING THE BUSH BABY
STEALTH BOTTLE CAMERA
Please read this manual before operating the
device and keep it handy. Separate areas contain
water on the top and bottom to give the
impression of a full bottle. We advise that you
NOT use this like a normal bottle of water by
repeatedly drinking from it, as this increases the
chance of water leakage/damage.
Your purchase should include:
1 x BushBaby Stealth Bottle Camera
1 x Remote Control
1 x Charging Adapter with Indicator Lights
1 x MicroUSB Cable
1 x Removable Battery
1 x Wall AC Adapter
1 x MicroSD Card Reader
1 x 16GB MicroSD Card
1 x User Manual

3 Version 2.1
GET FAMILIAR WITH YOUR BUSH BABY STEALTH
BOTTLE

4 Version 2.1

5 Version 2.1

6 Version 2.1

7 Version 2.1
BEFORE YOU START
To preserve battery power, your bottle will come
with the battery connector disconnected. Before
attempting to use the device, be sure to connect
the battery’s connector to the circuit board power
lead.
Note: If you are not located in the US, or if you
intend to use this product anywhere other than the
US, you will need to purchase a converter in order
to use the AC wall plug in and avoid damaging the
product. Because different countries use different
voltages in their electrical wiring, you will need a
converter that adapts to the current in your
particular country.
IMPORTANT WARRANY INFORMATION: If the
warranty sticker on your device has been removed
or tampered with, your lifetime warranty will be

8 Version 2.1
voided. You may be charged fees or denied a
return should this happen.
OPERATING THE BUSHBABY STEALTH BOTTLE
CAMERA
IMPORTANT NOTICE: Allow the device to charge 6 –
8 hours before using.
REMOVING AND CHARGING THE BATTERY
1. Remove battery from the bottle (see pages
3 and 4).
2. Disconnect the battery connector that is
connecting the battery to the circuit board
(see page 4). Be careful not to pull on the
wires as that could damage them.
3. Connect the connector on the battery to
the connector on the charging adapter (see
page 6).
4. Plug the provided USB cable into the other
end of the charging adapter.

9 Version 2.1
5. Plug the other end of the USB cable into
the wall AC adapter and plug it into the
wall.
6. Wait 6 to 8 hours.
a. The larger the battery capacity, the
longer it takes to charge.
HOW TO TURN ON THE BUSHBABY STEALTH BOTTLE
CAMERA
1. Press the Power Button on the remote
control one time (see page 5). Your device
is on when you see an indicator light inside
of the water bottle. The device is now in
Standby mode.
HOW TO RECORD VIDEO ON THE BUSHBABY
STEALTH BOTTLE CAMERA
1. In standby mode, press the Video button
on the remote control one time (see page
5). The indicator light inside of the device
will flash three times and then turn off.

10 Version 2.1
a. Videos will be recorded
continuously and saved in 20
minute intervals.
HOW TO SET UP MOTION DETECTION
1. In Standby mode, press the Motion
Detection button one time (see page 5).
The indicator light will flash three times,
and then turn off.
2. The unit is now in motion detection mode
and will begin recording video once motion
is detected. There will be no LED indicator
to indicate when motion is detected.
HOW TO STOP RECORDING
1. To stop recording, you will need to press
the same button you used to begin
recording.
a. If you pressed the Video button,
press the Video button once more.