START HERE
Refer to main diagram
and Figure 1
Refer to Figure 3
1. Attach the ButtKicker®Advance to the CMAK mounting plate
2. Position the CMAK mounting plate under your furniture
a. Place the ButtKicker®Advance on the CMAK mounting
plate on the side opposite the rubber feet.
b. Insert the carriage bolts up through the square holes
and secure them in place with the star washers and
acorn nuts using the supplied wrench to make sure the
bolts are tight.
c. Connect the supplied speaker wire to the red and black
speaker terminals on the ButtKicker®Advance unit.
a. If possible, put the CMAK mounting plate under a leg
at the center of the furniture. If there isnt a leg at the
center, place it under one of the corner legs.
b. Sometimes, there is room to hide the ButtKicker®
Advance on the inside of the furniture. You may need
to pull back the dust cover to provide access to the
inside of the furniture.
Note: Make sure there is proper ventilation and clearance for the ButtKicker®Advance
if placed inside the furniture.
c. It is very important that the other legs of the furniture
are supported using the supplied rubber isolators. If
possible, these should be screwed into the legs using
the supplied wood screws. However, if needed, they can
simply be placed under the other legs of the furniture.
3. Set up the Power Amplifier BKA300-4
a. Using the banana plugs, connect the speaker wire from the
ButtKicker®Advance to the output terminal on the amplifier.
b. Plug one end of the RCA audio cable into the subwoofer
output of your A/V processor and the other end into
the RCA In on the back of the RF Transmitter.
Note: The supplied RCA Y connector or Speaker Level Interface Adaptor may be
used to enable the use of both a subwoofer and the ButtKicker®Advance with your A/V
processor or to connect to an A/V processor that does not have a RCA subwoofer output.
Use either the Y connector or the Speaker Level Interface Adaptor but not both.
c. Connect the AC adapter into the back of the RF
Transmitter and plug into an electrical outlet.
d. Plug the RF Receiver unit into the RF Receiver input
on the back of the BKA300-4 Power Amplifier. The
green light on the side of the RF Receiver indicates that
the unit is powered on.
Note: Refer to the BKA300-4 Owners Manual, Wireless Setup section for complete
setup and usage details.
4. System Adjustment
a. Turn on the rest of your home theater; play a movie or
music track with some deep low frequency material at
normal listening volumes.
b. Next slowly increase the Intensity of the BKA300-4
Power Amplifier using the Remote Control or front
panel controls until your desired level of intensity for
the ButtKicker®Advance is reached.
c. Invite your friends and family to watch a movie
or listen to music and ENJOY!
Refer to main diagram,
Figure 1 and Figure 2
