C-TECH-I LI-VLK-1 User manual

C-TECH-I, INC USERS' GUIDE
Single Lever Pull-out Kitchen Faucet
Applied Models: LI-VLK-1, LI-VLK-5, LI-VLK-6, LI-VLK-8, LI-VLK-9
Thank you for selection our products.
This Instruction contains the usage, manipulation, maintenance etc. To help
insure that the installation process will proceed smoothly, please read these
instructions carefully before you begin.
Note:
zBefore installing the faucet, please read the instruction carefully.
zTo avoid the impact of poor water quality on the usage of the faucet, we
recommend that you install the aerator and check valve in water supply
pipe which manufactured by our company. Please refer to the local dealer
for details.
zDo not disconnect the faucet body by yourself.
Tools and Materials:
zAssorted Screwdrivers
zAdjustable Wrench
zPipe Wrench
zWrench
zPliers
zThread Sealant
zOther tools as needed
1

C-TECH-I, INC USERS' GUIDE
Installation
1. First, take the rubber washer through the pipe cover. Insert the body into the
faucet hole of the sink (See figure 1 and figure 2);
44
37
43
Figure 2
Insert
44
37
43
Figure 1
2. Take the two washers through the pipe cover. Then revolve the locknut onto
the pipe cover and fix the faucet on the sink by the washers（See figure 3 and
figure 4）;
37
43
Figure 4 47
48
45
46 Revolve
44 37
43
Figure 3 45
46
3. Install the pull-out spray as follows(See figure 5 and figure 6):
Figure 5
Insert
1
5
30
Spray
Spray
30
537
43
Figure 6
Insert
1
9
2
Check valve inside
Check valve inside
2

C-TECH-I, INC USERS' GUIDE
4. Revolve the two inlet hoses and the spray hose into the faucet body; do not
use excessive force（See figure 7 to figure 11）;
Figure 9
Revolve
1
58
37
29
25
29
29
29
25
1
39
Figure 8
Insert 1
58
37
37
Figure 7
Insert
1
58
Figure 10
Revolve 1
40 and 58
Insert
37
49 and 50
Figure 11
1
49 and 50
40 and 58
5. Before connecting the inlet hose to the indoor water supply pipe, you should
pay attention to the three points as follow:
1) Flush the pipe;
2) There are no stings at the ends of the water supply pipe;
Flush the pipe
3) Using other seal materials at the ends of the inlet pipe is not allowed.

C-TECH-I, INC USERS' GUIDE
The configuration of the faucet
4

C-TECH-I, INC USERS' GUIDE
Maintenance:
1. According to the water quality, periodically disconnect the aerator cover for
cleaning to avoid jam (See figure 1, figure 2 and figure 3). It will prevent the
leakages and cartridge damage if the spout jams;
2. The water supply pressure should be 140 and 860 kpa (Contain cold water
and hot water);
3. The faucet should be cleaned periodically to keep the surface bright.
Cleaning:
1. Flush with clean water and dry with soft cloth only;
2. Do not use any metallic scourers such as steel brush, hard cloth, polisher to
clean the faucet;
3. Do not use acid or alkalescent detergent to clean the faucet.
5