C-TECH-I LI-VLK-3 User manual

C-TECH-I, INC USERS' GUIDE
Single Lever Kitchen Faucet
Applied Models: LI-VLK-3, LI-VLK-4, LI-VLK-7
Thank you for selecting our products.
This Instruction contains the usage, manipulation, maintenance etc. To help
insure that the installation process will proceed smoothly, please read these
instructions carefully before you begin.
Notes:
zBefore installing the faucet, please read the instruction carefully.
zTo avoid the impact of poor water quality on the usage of the faucet, we
recommend that you install the aerator in water supply pipe which
manufactured by our company. Please refer to the local dealer for details.
zDo not disconnect the faucet body by yourself.
Tools and Materials:
zAssorted Screwdrivers
zAdjustable Wrench
zPipe Wrench
zWrench
zPliers
zThread Sealant
zOther tools as needed
1

C-TECH-I, INC USERS' GUIDE
Installation
1. First, take the rubber washer through the cartridge seat. (See figure 1);
9
16
Figure 1
13
2. Revolve the two inlet hoses into the faucet body; do not use excessive force
（See figure 2）;
9
16
22
21
Revolve
3. Insert the two inlet hoses into the faucet hole of the sink（See figure 3）;
Figure 3
Insert
16
21 and 22
2

C-TECH-I, INC USERS' GUIDE
4. Take the rubber washer and the plate washer through the cartridge seat. Then
revolve the locknut onto the cartridge seat（See figure 4 and figure 5）;
21 and 22
17
18
Figure 4
21 and 22
17
18
19
Revolve
20
Figure 5
5. Revolve the locknut and fix the faucet on the sink by the washers;
Figure 6
21 and 22
17
18
20
19
6. Before connecting the inlet hose to the indoor water supply pipe, you should
pay attention to the three points as follow:
1) Flush the pipe;
Flush the pipe
2) There are no stings at the ends of the water supply pipe;
3) Using other seal materials at the ends of the inlet pipe is not allowed.
3

C-TECH-I, INC USERS' GUIDE
4

C-TECH-I, INC USERS' GUIDE
Maintenance:
1. According to the water quality, periodically disconnect the aerator cover for
cleaning to avoid jam (See figure 7, figure 8 and figure 9). It will prevent the
leakages and cartridge damage if the spout jams;
Revolve
Figure 9
8
9
10
Brush
Figure 8
Revolve
Figure 7
2. The water supply pressure should be 140 and 860 kpa (Contain cold water
and hot water);
3. The faucet should be cleaned periodically to keep the surface bright.
Cleaning:
1. Flush with clean water and dry with soft cloth only;
2. Do not use any metallic scourers such as steel brush, hard cloth, polisher to
clean the faucet;
3. Do not use acid or alkalescent detergent to clean the faucet.
5