Ca'Bano 28001D User manual

BS02601727
BS02601727
Installation Notice
1. Please lay water pipes in accordance with this manual.
2. Floor drain should be installed on the site.
3. The product should be installed only after the completion of house
interior decoration in case the paint or other chemicals erode the
mixer surface.
4. Clean pipes to get rid of mud, sand or other debris blocked in pipes
before installation.
5. Check whether the threads can be matched. Otherwise, installing
forcefully will damage the components.
6. After installation, check all the joints to make sure they are firmly
connected. Run the water. Turn on and off repeatedly to ensure no
leaking problem. After that, the product is ready for normal use.
7. Hand the manual to users.
Operation Notice
1. The product is used under water pressure 0.05~1.0 MPa, water
temperature 4~90°C.
2. Do not hang heavy things on the product.
3. Remember to turn off the mixer if no water comes out of it
(Especially when nobody in the house or during the decoration period).
4. Clean the surface of the product regularly to keep it glossy. Note: Please
do not use inappropriate tools such as sharp brushes, rough sponges,
scouring pads or corrosive detergent. And it is not recommend to use the
detergent sold in the market, because its formula changes frequently.
Please clean the product with wet cloth and soapy water after usage.
Then rinse the soap off with clean water and dry with a soft cotton cloth.
5. When indoor temperature drops below 0°C, take necessary measures
(Keep the product warm, close windows) to prevent the product from
frost cracking (Especially when windows open for air ventilation while
nobody in the house).
6. Adjust the temperature before use to avoid scald.
7. Do not disassemble the product without help from the professionals.
Installation Diagram
Installation Steps ( Fig. 1~6 )
The installation diagram is only for reference,
the product is subject to the real object.
Wrench
Prepare below tools.
Locking spanner (supplied)
Spanner (supplied)
Mixer body
Rubber washer
Mounting washer
Locking nut
Disassemble the
locking nut, mounting
washer and rubber
washer from the mixer
body in turn.
#28001D
Single hole basin faucet
INSTALLATION GUIDE
Last revision: October 23rd

BS台式龙头
Upper lift rod
Lower lift rod
Knitted
hose
Insert the upper lift rod into the
slot on the back of the mixer
body. Connect the upper lift
rod with the lower lift lod.
Screw the knitted hose
(applied torque ≤ 5N·m) with
red(hot) in front and bule(cold)
in back.
Pass the mixer body through
the counter top, install the
rubber washer and the
mounting washer. Tighten
them with the locking nut.
Connect the two
knitted hoses to the
two triangle valves
(Red for hot water
and blue for cold
water). Connect the
lower lift rod to the
waste set.
Hot water
triangle valve
Cold water
triangle valve
Waste set
Run the water to
check if the product
is well installed.
Counter top
Cleaning
Aerator
Spanner
If flow rate of the water gradually decreases after some time, it may results
from aerator blockage. Please clean the aerator as shown in figure above:
Turn off the handle, disassemble the aerator with the spanner, wash the
aerator and then install it back.