Cable-Tronix CT-9X1HD User manual

INSTALLATION MANUAL
CT-9X1HD
1-In 9-Out Audio/Video Distribution Amplifier
PACKAGE CONTENTS
1

2
This package contains:
One CT-9X1HD Audio/Video Distribution Amplifier
One 9V AC Power Adaptor
One CT-9X1HD Installation Manual
PRODUCT DESCRIPTION
The CT-9X1HD is a component audio/video 9-port HDTV distribution amplifier. The unit is
designed to allow any audio/video source with Y, Cb, CR or Y, Pb, Pr outputs (components) to
distribute audio and video from a single source to nine different locations without any signal loss.
The CT-9X1HD also supports composite video and digital audio. 480i, 720p, 1080i, and 1080p
resolutions are supported making it ideal for high definition signals.
SPECIFICATIONS
CT-9X1HD
1-In 9-Out Distribution Amplifier Specifications (Typical)
Video
1. Video Impedance 75 ohm
2. Video Bandwidth >100MHz (HDTV requires 37MHz minimum)
3. Video Gain 2V unterminated, 1V into 75 ohms
4. Return Loss 18dB
5. Port to Port Isolation 32dB
6. Out to In Isolation 60dB
7. Nominal Input Level 1 Volt peak-to-peak
Audio (Analog)
8. Audio Input Impedance 22K ohm
9. Audio Output Impedance 1K ohm
10. Gain Unity
11. THD 0.05%
12. Frequency Response 20Hz to 100kHz
13. Channel Separation >75dB
14. Port to Port Isolation 60dB
15. Out to In Isolation 60dB
16. Signal to Noise 100dB@2V (out)
17. Nominal Input Level 1 Volt peak-to-peak
18. Digital Audio Supports standard SPDIF digital audio. Unity gain when terminated into 75 ohms (2X gain high impedance). Greater than 50MHz of
bandwidth to ensure minimal degradation.
General
19. Power 9V AC @1000mA with a 2.1mm center coaxial connector.
20. Dimensions

INSTALLATION
1. UNPACKING and HANDLING
Each unit is shipped assembled and factory tested. Ensure that all accessories are removed
from the container before discarding packing material
2. MECHANICAL INSPECTION
Inspect the front and rear of the equipment for shipping damage. Make sure the equipment is
clean, and no connectors are broken, damaged, or loose. If equipment appears to be
damaged or defective please contact your distributor or Cabletronix at 1-610-429-1511 for
assistance.
3. PRODUCT DIAGRAM
INSERT IMAGE and CONNECTIONS HERE
4. HARDWARE CONNECTIONS
a. Connect the signal source’s component video (Y, Pb, Pr) output to the distribution
amplifier’s component video (Y, Pb, Pr) input. Or, connect the signal source’s
composite video output to the distribution amplifier’s composite video input.
b. Connect the signal source’s audio L/R output to the distribution amplifier’s audio L/R
input.
c. Connect your TV or monitor’s component video (Y, Pb, Pr) input to the distribution
amplifier’s component video (Y, Pb, Pr) OUTPUT 1, OUTPUT 2, OUTPUT 3, or
OUTPUT 4. Or, connect your TV or monitor’s composite video input to the distribution
amplifier’s composite video OUTPUT 1, OUTPUT 2, OUTPUT 3 or OUTPUT 4.
d. Connect your TV or monitor’s audio L/R input to the distribution amplifier’s audio L/R
output.
Troubleshooting assistance can be found on-line at www.cabletronix.com in addition to support
from Cabletronix sales engineers at 1-610-429-1511.
3