ZA12KW MASTER AMPLIFIER
ZA12KW MASTER AMPLIFIER
ZA12KW SLAVE AMPLIFIER
ZA12KW SLAVE AMPLIFIER
HeadUnit
ZA12KW Amplifiers' Linked minimum impedance is 2 ohm.
Working Voltage is 8.5V to 18Volts
Connect speaker cable ( + ) on master ZA12KW amplifier to subwoofer ( + )
Connect speaker cable ( + ) on slave ZA12KW amplifier to subwoofer ( )
Connect speaker cable ( ) on master ZA12KW amplifier to speaker cable ( ) on slave
ZA12KW amplifier
Minimum daisy chain connection impedance is 2 ohm
Do not use daisy chain connection aW1 ohm
1. SPECIFICATION
ZA12KW : 12,000 Watts RMS @ 1 ohm <1% THD, Linked Power : 24,000 Watts @ 2ohm
Input level adjustment range : 6V to 200mV
Low pass Filter adjustment range : 35Hz ~ 250Hz
Low pass Filter slope : 24dB / octave
Subsonic Filter adjustment range : 10Hz ~ 50Hz @ 24dB / octave
Phase : 0 ~ 180 degree
Bass boost range : 0dB to + 9dB
Bass Boost center frequency adjustment range : 45Hz
Minimum THD & N : < 0.1%
2. DAISY CHAIN CONNECTION
Daisy chain connection DOORZV\RXWROLQNWZR=$.:DPSOLILHUV
Please read the following connection diagram carefully to make correct connection.
Connect the Master ZA12KW amplifier to the head-unit6et WKH 2873870$67(5
and ,13876/$9( switch to 0$67(5 position.
Connect 0$67(5DPS WR 6/$9(ampXVLQJ5&$MDFNVDVVKRZQLQGLDJUDP.
Set 6/$9( ZA12KW amplifier 2873870$67(5 & ,13876/$9( switch to 6/$9( position.
Fully adjusted signal is transferred
from master to Slave Amp via
RCA Cable.
RCA out on Master to RCA In on Slave
Master ZA12KW positive terminal
to
Positive terminal of Subwoofer
Slave ZA12KW positive terminal
to
Negative terminal of Subwoofer
