Cambium Networks PTP 820C User manual

1
PTP820 C/S and RFU-C to Dragonwave Antenna Interface
– Installation Instructions
This guide explains how to mount PTP820 mediation devices on Dragonwave
antennas.
List of Kits
Item
Description
Quantity
Remarks
1
PTP820 C/S and RFU-C to Dragonwave Antenna adaptor
1
2
RFU-C or PTP820C OMT
1
Mediation devices:
PTP820C OMT RFU-C OMT
Required tools
Metric offset hexagon key wrench #6
Metric wrench 13 mm
Procedure
1Carefully clean and grease the O-ring mounted on the Dragonwave
antenna using the grease tube supplied in the PTP820C/S and
RFU-C Dragonwave antenna adaptor kit box.

2
2 Gently slide the PTP820C/S and RFU-C Dragonwave antenna adaptor onto
the Dragonwave antenna. Make sure that the hook is facing up and close
the latches firmly.
3If the O-ring is already mounted to the PTP820C/S and RFU-C side of
the Dragonwave antenna adaptor, just remove gently the adhesive tape. If the
O-ring is not mounted, place the O-Ring supplied in the RFU-C
Dragonwave Interface kit ontothe PTP820C/S and RFU-C Dragonwave
interface. Make sure the mounting direction is correct, as shown in the
section view.
Hook Facing Up
Clean and grease
O-ring

3
4Mount the OMTonto the PTP820C/S and RFU-C Dragonwave antenna
adaptor using the screws provided in the OMT kit.
5Mount the Radio according to the relevant radio installation instructions.
PTP820C OMT
RFU-C OMT