Camp Chef Pro 90X User manual

How to change the Valves/Igniter
on the Pro90X –Pro60X
Warning: Before you begin
make sure the item is removed
from the propane tank.

To remove all the knobs from
the front of the stove, just pull
straight out

Remove all the screws
that secure the front face
plate.
Pull off and set aside.

Undo the bolts screw
on the bottom of the
valve connecting it to
the manifold. The
manifold will then fall
off
Remove the
igniter wires
to each of the
valves.
Note: After putting the stove back together, you will want to
make sure the ignition knob is aligned correctly with the prong
on the ignitor.
You may even want to use a mallet and gently tap it on, to
insure it will not strip out again.

Unscrew the valve from
the burner. Please note
that the spring and the
vent will come off too.

If after troubleshooting with this
manual, if you are still experiencing
problems, please contact out
customer service department. Our
agents will be happy to help. You
can contact them at
1-800-650-2433
Note: The Manufacture is not liable for any replacement parts, equipment,
and/or injury due to improper installation or modification.