Cannon Security Products Digital Door Viewer User manual

Digital Door Viewer
User Manual
1.Power Button:
Press and release the power button, then the unit
will continue working for the next 10 seconds.
2.Light Indicator:
If the light indicator turns on, please replace the
batteries.
Door thickness: 1.57” to 2.76” (40mm-70mm)
Barrel diameter: 9/16” to 27/32” (14mm-22mm)
Sensor: 0.3 Mega Pixel CMOS
LCD screen: 3.5” TFT
Power source: 4 AA Batteries
Size: 5.31”w x 3.34”h x .96”d (135mm x 85mm x 24.5mm)
Weight: 12.4 oz (350g)
Operation:
Specification:

②
⑤
⑥
⑦
①③
AA AA AA AA
Attention：
1.Please read the instruction manual before use.
2.DO NOT disassemble the camera or the mainbody.
3.Handle with care.
4.Please unscrew both screws from the bottom of the
digital door viewer, take out the holding plate
and prepare to install.
and take
off the adhesive on it
Package Contents:
④
⑧
Digital door viewer①
Before installation:
Prior to mounting the peephole viewer, please make sure
you have installed the batteries included.
Installation:
1. Replace the existing door viewer or drill a 14mm hole
in the door at eye level. Insert the camera from the
outside while inserting the washer between the back of
the lens and the door. Make sure that the arrow mark on
front of the camera points upwards.
4 AA batteries③
Holding plate⑤
Camera⑦
②Locking bolts 2 pcs
Screws④
Washer⑥
Locking barrel⑧
2. Fit the holding plate over the end of the lens then screw
the locking barrel on to the threaded part of the camera
and tighten, this will hold the plate to the door. You can
then secure the plate with 2 or 3 screws (provided).
Make sure that the arrow on the plate points upwards.
3. The wire of camera should be connected to the socket
in the back of the digital door viewer,excess wire should
be attached behind the small hook.
4. Hook the over the bracket at the top
of the locking plate and secure with two small bolts
through the holes in the bottom of the
case.
digital door viewer
digital door
viewer