Canon PIXMA MX860 series User manual

<< Previous Next >>
Getting Your Multifunction
Back On Your Network
After A Router Or Network Change
PIXMA MX340 / MP495 / MP620 / MX860 / MP980
Mac OS
1

If any of the following situations exist, run the Canon IJ
Network tool to send the new configuration settings to
your printer*:
•You have replaced your Router or Access Point
•You want to use a different wireless network
•Router settings have been changed.
* You must connect the printer and computer via USB cable temporarily in order to
send the settings information to your printer.
2
<< Previous Next >>

Run the Canon IJ Network Tool << Previous Next >>
3
1. Verify you are connected to the network
(SSID) you will be using with the printer.
2. Start the IJ Network Tool by browsing to the
Library\Printers\Canon\BJPrinter\Utilities
folder and double-click Canon IJ Network
Tool
3. When the Network Tool finishes searching,
select Setup in the dropdown list at the
upper left of the window
4. If the following message appears, click OK to
continue.
5. On the Setup screen, select the model,
then click OK.. The type will be listed as
Canon USB.

Run the Canon IJ Network Tool << Previous Next >>
4
6. On the Confirm Connection Access Point
screen, verify that the Access point is the
one to which you wish to connect, then
click Yes. If you wish to connect to a
different Access Point, click No and proceed
to Step 7.
If the Confirm Access to Keychain dialog
appears, click Allow.

Run the Canon IJ Network Tool << Previous Next >>
5
7. On the Access Points screen, select the
Access Point to be used , enter the network
password in the space provided and click
Connect. If you are not using encryption
(not recommended), this step is skipped. If
you do not know this password, you may be
able to obtain it using the Canon PIXMA
Wireless Setup Assistant.

Run the Canon IJ Network Tool << Previous Next >>
6
8. After searching for printers, the Setup
Completion window appears. Click Next.
9. Click Next on the Connection Performance
Measurement screen. The Connection
Performance Measurement screen only appears
when using the oldest version of the IJ Network
Tool. Skip to Step 11 if the Connection
Performance Measurement screen does not
appear.

Run the Canon IJ Network Tool << Previous Next >>
7
10. When the measurement has completed,
click Finish.
11. Select the printer and click Add. Be sure
canonijnetwork is listed in the Kind column.
*This window varies by OS version

Downloading and Installing the Drivers << Previous
8
If the default printer browser does not list the
network printer , click More Printers and select
Canon IJ Network in the dropdown. Then select
the printer and click Add.
12. Select the scanner on the Scan-from-PC settings
screen, then click OK
13. At this point setup is complete. If any more Canon IJ
Network Tool screens appear, close or cancel them,
then disconnect the USB cable.