Carex Transport Chair User manual

Mobility & Comfort for
your active lifestyle
Transport Chair
Fast & easy assembly, no tools required
Carex Health Brands • Sioux Falls, SD • www.carex.com
42-A22600_05 ©2016

Adjust leg rest length
The length of the leg rests have been preset.
To adjust the length, follow these steps:
6
Transport chair frame
Two front wheels
Two rear wheels Two quick release axles
Note: actual items may vary from what is shown
(used in rear wheel assembly)
Two leg rests
NOTE: The lowest part of the
leg rest should not be less than
2 inches from the ground to
permit proper clearance.
Adjust length as needed, making
sure to lock button in place.
Press silver button
TO PREVENT
TIPPING WHILE
SEATED DO
NOT PUSH
YOURSELF WITH
YOUR FEET.
Two hand nuts Two bolts and washers
(used in front wheel assembly)
21
Part Check
1
CLICK

CLICK
Rear wheel assemblyLeg rest assembly 25
1
1
2
2
5
CLICK
3 4
1. Turn chair upside down, insert quick release axle through wheel and
into fitting as shown.
2. Listen for audible “click”.
To avoid serious injury, ensure that the Quick
Release Axle and snap button have fully protruded
through the hole in the back leg.

Position backrestFront wheel assembly 43
1
3
2
Yes NO
Make sure Snap buttons are
securely locked into place (2)
on both sides of each tube, and
hex bolt is fastened completely
through the metal leg tube
(3). To avoid serious injury,
transport chair must
be properly assembled.
1 2
CLICK
CLICK
34