Carmanah MX Series User manual
MX Series
MX 400 DRAW LATCH KIT INSTALL GUIDE
LEVEL 4
Carmanah Technologies Corp. | 250 Bay St, Victoria, BC V9A 3K5, Canada | 1.250.380.0052 | customersupport@carmanah.com | carmanah.com
91637REVA
1. Locate two indentations on right side of cabinet shown. Open cabinet, move cables aside and
drill two 0.188" dia. holes through cabinet wall using indentations to locate drill bit. Remove
metal shavings.
2. Remove and dispose of four screws and existing latch from door standoffs on inside of door.
2
MX 400 DRAW LATCH KIT INSTALL GUIDE
LEVEL 4
Carmanah Technologies Corp. | 250 Bay St, Victoria, BC V9A 3K5, Canada | 1.250.380.0052 | [email protected] | carmanah.com
4. Use provided screws and nuts to fasten door stop bracket and latch to cabinet as
shown into holes drilled in Step 1.
3. Install hole plug into door hole as shown.
A padlock with shackle diameter up to 1/4" can be used to secure the cabinet.
Gasket
NOTE: READ ALL INCLUDED INSTALL GUIDES BEFORE SYSTEM INSTALLATION
Other manuals for MX Series
7
This manual suits for next models
1
Table of contents
Other Carmanah Industrial Equipment manuals
