Casa Lusso Eden ED150 User manual

www.casalusso.com.au
CONGRATULATIONS ON THE PURCHASE OF YOUR NEW CASA LUSSO TAPWARE,
WE HOPE YOU AND YOUR FAMILY ENJOY YOUR NEW PRODUCT AND CONSIDER US
FOR ANY FUTURE PROJECT. CASA LUSSO PRODUCTS HAVE BEEN MANUFACTURED
UNDER THE HIGHEST STANDARDS OF QUALITY AND WORKMANSHIP.
FAILURE TO COMPLY WITH ANY OF THE ABOVE INSTRUCTIONS WILL VOID ALL WARRANTIES
Eden In Wall Mixer with Diverter - Installation Instructions
Chrome
ED150
Matte Black
ED150MB
Product Code: ED150 / ED150MB
Premium Warranty (Domestic Use) :
15 year Ceramic cartridge replacement only
7 year Replacement products and parts1
1 year parts & labour2
Material: Solid Brass Construction
Made to Australian Standards code:
AS/NZS 3718
Water supply - Tapware LN030023
1 Excludes Damage to ceramic disk cartridges from pieces
of copper tube, plastic tube, sand, dirt or thread tube etc.
All speciality finishes are subject to 2 year replacement
product and parts and 1 year replacement product and
parts & labour. 2 Jumper valves and ceramic disk spindles;
1 year parts only.
FEATURES
GENERAL INFORMATION
MAINTENANCE
• Clean regularly using mild soap and dry with a soft cloth.
• Do not use abrasive cleaners, harsh detergents or citrus based cleaners on any products
as these will scratch the surface.
• Tightening or adjustment of Tapware over time is considered general maintenance.
• Failure to clean/replace aerators/flow restrictors as required will void warranty.
• Damage to finishes that arise from installation or post installation will void warranty.
The warranty will not apply if:
• The product has been damaged by improper use;
• The product has not been used in accordance with any applicable instruction guide;
• The purchaser has attempted to modify or repair the product;
• The purchaser has failed to observe the cleaning and maintenance guidelines;
• The product is not installed by a licenced Plumber.
• Flow controllers/ aerators not regularly cleaned/ replaced.
Product warranties are personal to the person who acquires the product for their own consumption or use and not for resale
or resupply. Claims with this product cannot be made by anyone other than the consumer. Where a product is covered by
parts and labour warranty, the warranty covers both the repair of the defective part or the provision of a spare part to
replace the defective part and the installation of that part.Where a product is covered by parts only, the warranty covers
both the repair of the defective part or the provision of a spare part in replacement. It does not include the removal of the
defective part or the installations of the repaired or replaced part. We reserve the right to provide minor components (e.g.
handles, aerators, hoses, dress rings and washers) as ‘Parts Only’ to the customer. Casa Lusso reserves the right to alter, or
amend this warranty offer in writing at any time.
15 YEAR
WARRANTY

CONTENTS













Diverter Button
Diverter Assembly
O-ring
Handle
Hex Key Screw
Concealed Push Cap
Brass Dome Cover
Cartridge Securing Nut
Cartridge
Faceplate
O-ring
External Mixer body
Internal Mixer body
1. Mount the mixer body into the wall
IT IS IMPORTANT TO FLUSH OUT THE
WATER PIPES BEFORE INSTALLING THE MIXER.
2. Connect the water supply to the Hot/Cold Inlets of the
mixer body marked H and C.
3. Install the faceplate onto the mixer body.
4. Install the handle and diverter onto the
mixer body and tighten with allen key.
IMPORTANT
IT IS IMPORTANT TO FLUSH OUT THE WATER
PIPES BEFORE INSTALLING THE MIXER.
Hot and cold water inlet pressures should be equal.
Inlet pressure range: 150 – 500 kPa
New Regulation:
500 kPa maximum operating pressure at any
outlet within a building. (Ref. AS/NZS 3500)
Maximum hot water temperature: 80oC.
INSTALLATION
www.casalusso.com.au
FAILURE TO COMPLY WITH ANY OF THE ABOVE INSTRUCTIONS WILL VOID ALL WARRANTIES













Internal
Mixer body
Eden In Wall Mixer with Diverter - Installation Instructions