CASAINC Luxey42 Owner's manual

IMPORTANT INSTRUCTIONS & OPERATING MANUAL
Luxey42,Luxey 50,Luxey 50 WH,
Luxey 60,Luxey 72,Luxey 84,Luxey 95
WARNING
Read and understand this entire owner’s manual, including all safety
information, before plugging in or using this product. Failure to do so could
result in fire, electric shock, or serious personal injury.
CAUTION Keep this owner’s manual for future reference. If you sell or give this product
away, make sure this manual accompanies this product.
NO VENTING REQUIRED
120V AC; 60 Hz; 1500 Watts

First make the bulged screw tube on the wall,
second put the wall haning on the wall,
third fix the wall hanging by self-tapping screws.

Used for Lexey 42,Lexey 60 Used for Lexey 72,Lexey 95

1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
11.
12.
IMPORTANT INSTRUCTIONS
Read all instructions before installing or using this heater
This heater is hot when in use. To avoid burns, do not let bare skin touch hot surfaces. Keep combustible
materials, such as furniture, pillows, bedding, papers, clothes, etc. and curtains at least 0.9 m from the front
of the heater and keep them away from the sides and rear
Extreme caution is necessary when any heater is used by or near children or invalids and whenever the
heater is left operating and unattended.
Do not operate any heater after it malfunctions. Disconnect power at service panel and have heater
inspected by a reputable electrician before reusing.
Do not use outdoors.
To disconnect heater, turn controls to off, and turn off power to heater circuit at main disconnect panel (or
operate internal disconnect switch if provided).
Do not insert or allow foreign objects to enter any ventilation or exhaust opening as this may cause an
electric shock or fire, or damage the heater.
To prevent a possible fire, do not block air intakes or exhaust in any manner.
A heater has hot and arcing or sparking parts inside. Do not use it in areas where gasoline, paint, or
flammable vapors or liquids are used or stored.
Use this heater only as described in this manual. Any other use not recommended by the manufacturer may
cause fire, electric shock, or injury to persons.
This heater may include an audible or visual alarm to warn that parts of the heater are getting excessively
hot. If the alarm sounds (or illuminates), immediately turn the heater off and inspect for any objects on or
adjacent to the heater that may have blocked the airflow or otherwise caused high temperatures to have
occurred. DO NOT OPERATE THE HEATER WITH THE ALARM SOUNDING (OR ILLUMINATING).
“SAVE THESE INSTRUCTIONS”
This heater is for use on 120 volts. The cord has a plug as shown below Figure. An adapter as shown at
C is available for connecting three-blade grounding-type plugs to two-slot receptacles. The green grounding
lug extending from the adapter must be connected to a permanent ground such as a properly grounded
outlet box. The adapter should not be used if a three-slot grounded receptacle is available.

Instructions importantes
1. Lisez toutes les instructions avant d'installer ou d'utiliser ce radiateur.
2. Ce radiateur est chaud lorsqu'il est utilisé. Pour éviter les brûlures, ne laissez pas la peau nue toucher les
surfaces chaudes. Gardez les matériaux combustibles, tels que les meubles, les oreillers, la literie, les papiers,
les vêtements, etc. et les rideaux à au moins 0,9 m de l'avant du radiateur et éloignez-les des côtés et de
l'arrière.
3. Une extrême prudence est nécessaire lorsqu'un radiateur est utilisé par ou près des enfants ou des invalides
et chaque fois que le radiateur est laissé en fonctionnement et sans surveillance.
4. Ne faites pas fonctionner de radiateur après les dysfonctionnements. Débranchez l'alimentation au panneau
de service et faites inspecter le radiateur par un électricien réputé avant de réutiliser.
5. N'utilisez pas à l'extérieur.
6. Pour déconnecter le radiateur, tourner les commandes vers OFF et désactiver l'alimentation sur le circuit
du chauffage au panneau de déconnexion principale (ou faire fonctionner l'interrupteur de déconnexion interne
s'il est fourni).
7. Ne pas insérer ou permettre aux objets étrangers de pénétrer dans une ventilation ou une ouverture
d'échappement car cela peut provoquer un choc électrique ou un incendie, ou endommager le radiateur.
8. Pour éviter un éventuel incendie, ne bloquez pas les apports d'air ou ne vous échappez en aucune façon.
9. Un radiateur a des pièces chaudes et arc ou étincelles à l'intérieur. Ne l'utilisez pas dans les zones où
l'essence, la peinture ou les vapeurs ou liquides inflammables sont utilisés ou stockés.
10. Utilisez ce radiateur uniquement comme décrit dans ce manuel. Toute autre utilisation non recommandée
par le fabricant peut provoquer un incendie, un choc électrique ou une blessure aux personnes.
11. Ce radiateur peut inclure une alarme audible ou visuelle pour avertir que les parties du radiateur deviennent
excessivement chaudes. Si l'alarme sonne (ou illumine), éteignez immédiatement le radiateur et inspectez tous
les objets ou adjacents au radiateur qui pourrait avoir bloqué le flux d'air ou autrement provoqué des
températures. Ne faites pas fonctionner le radiateur avec le sondage d'alarme (ou illuminant).
12. «Enregistrez ces instructions»
Ce radiateur est utilisé sur 120 volts. Le cordon a une fiche comme indiqué ci-dessous. Un adaptateur
comme indiqué sur C est disponible pour connecter les bouchons de type de mise à la terre à trois
lames aux réceptacles à deux plans. La patte de mise à la terre verte s'étendant de l'adaptateur doit être
liée à un sol permanent comme une boîte de sortie correctement mise à la terre. L'adaptateur ne doit pas
être utilisé si un réceptacle mis à trois places est disponible.

Getting Started
Remove the fireplace from the box.
Remove the packaging. Place it inside the box or safely dispose elsewhere.
Package Contents
Electric Fireplace
Screws and Screw Anchors
Remote Control
Instrucon Manual
Features
Wide screen wall mount fireplace
LED technology for realiscflame effect
Soothing, mesmerizing logwood flame effect
Dual heat seng (750Was / 1500Was)
Built-in mer
Flames operate with & without heat
Adjustable flame brightness
Heat resistant tempered glass panel
Built-in overheang protecon, auto safety shut-off
1500 Was
Quick Reference Guide
Prior to installaon, please ensure that the voltage and capacity of your power outlet is
compable with your fireplace.
Your fireplace may emit a slight, harmless odor during its first use. This odor is a normal reacon
caused by the inial heang of internal fireplace parts and it will not occur again.
It is normal for fireplace to make a raling sound for a short duraon of me during its first use.
If your fireplace does not emit heat, please ensure the fireplace switch is on. For further
informaon, please refer to the Troubleshoong secon of this manual.

Helpful Advice Before Installation
Please retainall packaging unl you have checked and counted all the parts and other package
contents.
The package contains small apparatus which should be kept away from young children and
infants.
We suggest that you move all the smaller parts into a container to reduce the risk of losing them.
At least 2 people are required to install this eplace.
It is recommended to place your eplace near an exisng outlet, for ease of electric connecon.
Store your eplace in a dry, safe and dust-free place while drilling, for eplace installaon.
Do not aempt to wire new outlets or circuits. To reduce the risk of e, electric shock or injury
to persons, always have a licensed electrician perform maintenance and other repairs.
Connect to properly grounded outlet only

Tools Needed
Power drill
Screwdriver
Installation
Do not connect the replace to the power supply ul properly xed to the wall and the
instrucons are carefully read.
Make sure the area to be drilled does not have any hidden electrical wires or water and gas
pipes.
The minimum distances must be observed as shown in the diagrams below.
During installon of the replace, avoid any possible damage to concealed cables.
Please be careful when drilling holes.
This replace is designed to be permanently xed to a wall. Choose a wall that is sturdy enough
to hold the weight of the replace such as a brick or cinder block wall. If posoning on drywall,
it must be xed to studs. If you are not sure if the wall is stable enough, then consult a hardware
expert. The wall bracket must be xed horizontally with the cable routed to the boom right of
the replace.
For omum viewing of the fuel bed, it is recommended that there be a distance of 2 feet from
the bom of the replace relve to the oor (see gure for recommended xed dimensions).
Step One
Keep the top of the replace at least 3 feet away from the ceiling or other objects for omum
heat veon.
For omum viewing, place four marks on the wall with respect to the recommended xed
dimensions for the top screws (see gure on next page).
Note: use a level when marking the posons of the holes to ensure that the bracket is mounted
horizontally.

Step Two
Make sure the area to be drilled does not have any hidden electrical wires or water and gas
pipes.
The wall fixings provided is for concrete walls only; please use suitable fixings for your wall type.
If in doubt, contact a qualified hardware expert.
Place the three bulged screw tubes into the drilled holes and then screw in the self-tapping
screws. Screw the extended wooden screws into the 0.20” screw anchors so they protrude out
of the wall to angle the fireplace. Make sure that the screws are secured in place.
Have 2 people li�the fireplace and hook it onto the mounted bracket.
Check the fireplace for stability to see if it is securely mounted.
Instructions for Use
This fireplace can be operated either by the switches located on the right side panel of the
fireplace or the supplied remote control.
Turning On
Plug the fireplace into a power outlet.
Turn on the power switch which is located on the right side of the fireplace.

Remote Control
The remote control requires 2 AAA bries, which are not included.
Point the remote control directly at the replace.
The range is about 11.5 feet.
Troubleshooting
Problem Possible Solu�on
Unit does not work / does not heat
·Check if the unit is plugged in the power outlet.
·Check if the unit is in Standby mode. If so, turn
the unit ON.
·Check if the heat is turned OFF.
·Check for safety cut-ooperon.
No flame effect ·Check if the unit is plugged in the power outlet.
·Check if the unit is in Standby mode. Turn the
unit ON.

Touch screen panel operation
750 1500
750 1500
Touch the button will show C1,C2,C3 to different colors option.
Touch the button will show F1,F2,F3 to different colors option.
Flame effect

1

Model:Luxey 42,Luxey 50,Luxey 50 WH,Luxey 60,Luxey 72,Luxey 84,Luxey 95
Power supply:120V-60Hz
Power consumption: 1500W
Protection class: I
Light bulb: LED
This warrants to the original purchaser that this product is free from defects in material and workmanship
as of the date of purchase and that it will, under normal use and proper care, remain so for one year
from the date of purchase. Missing or initially defective parts will be replaced free of charge during the
period of this limited warranty. If parts are unavailable, comparable replacement of refund will be given.
The original dated sales receipt is required for all warranty claims. This warranty does not cover
damage which has occurred during transport from the point of purchase to the consumer’s home. This
warranty does not cover glass, light bulbs, batteries, transportation, labor, or other issues not associated
with the manufacture of the product.
This product is for residential use only. Any and all commercial use of this product voids all
warranties, and absolves the manufacturer from all liability.
Read and understand all assembly and operating instructions, and all safety information and warnings,
before use. The following will void this warranty: Damage caused by tampering, modifying, or
altering the fireplace insert in any manner; Damage due to incorrect assembly, improper care, misuse, or
abuse; Damage from being used with the wrong power source; Water damage; Damage caused from
this insert being used outdoors; Damage caused by using for excessive periods of time; Damage
caused by the insert being used in a commercial application; Damage from use as a primary heat
source;Other misuse or abuse not specifically listed herein.
This product is not intended to be used as a primary heat source. It is for supplemental heating
purposes only.
Website: www.casainc.com
Contact Phone Number: 888-257-3857
Service Contact : [email protected]