6. SAFETY PRECAUTIONS WHEN USING
7
SAFE POWER STATION PERFECT FOR YOU
A photovoltaic panel as an input for charging the internal battery shall be provided with an inverter and/or a charge
controller in accordance with UL 1741 or UL 62109-1;The external power supply shall be a power source in accordance
with the Standard UL 60950-1 and CAN/CSA C22.2 No. 60950-1,or UL 1310 and No. 1, CAN/CSA C22.2 No. 223, or No.1,
CAN/CSA C22.2 No. 223;A vehicle adapter that complies with the enclosure and input contacts requirements in the
Standard for Vehicle Battery Adapters, UL 2089, and Power Supplies, CAN/CSA C22.2 No. 107.1. The connector plug
shall incorporate a fuse or other protective device having a current rating not greater than 15 A.
INSTRUCTIONS PERTAINING TO RISK OF FIRE, ELECTRIC SHOCK, OR INJURY TO PERSONS IMPORTANT SAFETY
INSTRUCTIONS
1. WARNING – When using this product, basic precautions should always be followed, including the following:
a) Read all the instructions before using the product.
b) To reduce the risk of injury, close supervision is necessary when the product is used near children.
c) Do not put fingers or hands into the product.
d) Use of an attachment not recommended or sold by power pack manufacturer may result in a risk of fire, electric
shock, or injury to persons.
e) To reduce risk of damage to the electric plug and cord, pull the plug rather than the cord when disconnecting the
power pack.
f) Do not use a battery pack or appliance that is damaged or modified. Damaged ormodified batteries may exhibit
unpredictable behavior resulting in fire, explosion or risk of injury.
g) Do not operate the power pack with a damaged cord or plug, or a damaged output cable.
h) Do not disassemble the power pack, take it to a qualified service person whenservice or repair is required. Incorrect
reassembly may result in a risk of fire or electric shock.
i) To reduce the risk of electric shock, unplug the power pack form the outlet beforeattempting any instructed servicing.
j) WARNING – RISK OF EXPLOSIVE GASES.
1) To reduce risk of battery explosion, follow these instructions and thosepublished by battery manufacturer and
manufacturer of any equipment you intend to use in vicinity of the battery. Review cautionary marking on these
products and on engine.
k) PERSONAL PRECAUTIONS
1) Have plenty of fresh water and soap nearby in case battery acid contacts skin, clothing, or eyes.
2) Wear complete eye protection and clothing protection. Avoid touching eyes while working near battery.
3) If battery acid contacts skin or clothing, wash immediately with soap and water. If acid enters eye, immediately flood
eye with running cold water for at least 10 minutes and get medical attention immediately.
4) NEVER smoke or allow a spark or flame in vicinity of battery or engine.
5) Be extra cautious to reduce risk of dropping a metal tool onto battery. It might spark or short-circuit battery or other
electrical part that may cause explosion.
l) When charging the internal battery, work in a well ventilated area and do not restrict ventilation in any way.
m) Under abusive conditions, liquid may be ejected from the battery; avoid contact. If contact accidentally occurs, flush
with water. If liquid contacts eyes, additionally seek medical help. Liquid ejected from the battery may cause irritation
or burns.
n) Do not expose a power pack to fire or excessive temperature. Exposure to fire or temperature above 130°C may
cause explosion. The temperature of 130°C can be replaced by the temperature of 265°F.
o) Have servicing performed by a qualified repair person using only identical replacement parts. This will ensure that the
safety of the product is maintained.
p) Attach output cables to a battery and chassis as indicated below. Never allow the output clamps to touch one another.
1) Instructions shall include step by step directions for the proper use of the boosterfunction detailing the correct steps
to connect and disconnect the booster cables to the battery.
2) Each step shall be a different numbered item.
OPERATING INSTRUCTIONS
1) Instructions regarding battery charging, temperature limits for appliance and battery use and storage, and the
recommended temperature range for charging.
2) Indoor use only power packs.
3) Please charge it once every 3 months when not in use.
4) Portable power station does not support simultaneous charging and discharging.
5) Do not use one AC socket to connect multiple devices simultaneously.
6) Due to the characteristics of battery cells, we recommended that the user put the power station on hold for about
2 hours after the full load is discharged.
SAVE THESE INSTRUCTIONS
