688003 en ma 2012 2
1. FUNCTION AND PURPOSES
A This product is made for toasting of both fresh and frozen bread and other
flour products.
B As well as fresh and frozen meat products.
2. PRODUCT SPECIFICATIONS
Table 1. Specifications
Product name Salamander
Model *688.033
Input voltage range 220V~240V, 50Hz/60Hz
Power consumption 2000W
Chamber measurement 456×260×160 mm
Box measurement 630×320×280 mm
Temperature range 50-300ºC
Time control range 15 min.
Net Weight 13.5 kg
3. DISPLACEMENT AND STORAGE
During displacement, the machine should be carefully handled and prevented from being
jolted too hard. When still unpacked, it should not be stored outdoors, but in a ventilated
warehouse away from the possibility of contacting corrosive gas. It should not be placed
upside down. If for any reasons this product should be placed outdoors, please make sure
it is safe from rain and dirt.
4. PREPARATION
A Installation of power supply is suggested to be done by qualified personnel.
B By the temperature switch there is a light which lights up once the switch is turned
clockwise. Temperature will start rising once this move is made, temperature will rise
inside the oven gradually. Once the inner temperature reaches a certain level,
the light goes out and it’s ready to wake and toast the best foods you could ever
make with our products.
C Ratio Indicator Thermostat. The higher the degree of rotation is, the higher the
temperature will be. Through its function, various temperature values can be obtained.
If the temperature is turned to the highest, it will continuously heat up and the
temperature will be at the peak.
D During operation, if at any time the heat indicator light goes off, it means that it will
no further give heat; it will be necessary to turn the ratio indicator thermostat switch
again.
E Please remove the film attached on the body surface before operating.
F The cable must be connected in accordance with the safety standard of electric
appliances.
G Check if the voltage and frequency data accord with the requirement on
the product’s specifications.
H Please install a switch with double electrode between the machine and the plug.
When the machine is running, the voltage range should not exceed ±10%.