Cavalry EN-CAUG User manual

EN-CAUG
1
Thank you for purchasing the CAUG portable hard drive enclosure!
The ultra-small portable drive allows you to have maximum storage
space, maximum transfer speeds and portability; without the hassle
of using a bulky power supply.
The package contents include:
The CAUG enclosure
The USB Y power/data connector
Quick-Start Guide
You will need (not included):
One 2.5” SATA hard drive
EN-CAUG
Enclosure
Assembly Guide

EN-CAUG
2
Take enclosure out of box and remove plastic wrapper. Place the
CAUG enclosure on your work-surface; plastic side down.
Turn your 2.5” SATA hard disk drive upside down, so that the
metal side is facing the plastic enclosure.
Insert your 2.5” notebook disk slowly, at a shallow angle, until it
meets the SATA port inside the CAUG case. Lower the back-end
of the 2.5” drive slowly towards the plastic case while
simultaneously sliding it forward towards the SATA port. Once
it’s connected, it will look like this:
ENCLOSURETHE EN-CAUG ASSEMBLY GUIDE
1STEP ONE
2STEP TWO
3STEP THREE
Your CAUG is designed to be rugged. In order to accomplish this, the CAUG enclosure will fasten to the 2.5” hard drive
that you insert into it, permanently. As a result, you will need to format and test your 2.5” hard drive after connecting the
drive to the rst half of the enclosure (before closing the metal lid). See the instructions below:

(Optional) To ensure the drive receives enough power, plug in the two
large USB cable jacks into two free USB ports on your computer.
EN-CAUG
3
With the metal lid off, test the drive by connecting the USB
Y-cable to your computer and initializing/formatting the drive in
your operating system’s disk management utility.
Now that you have veried your drive is working, you can nish
assembling. First, close any applications which might be accessing the
drive, and disconnect the USB 2.0 cable.
Warning: Do not format the drive if you have pre-existing data!
For detailed instructions on initializing and formatting your drive for
Windows/MAC operatin systems, please go to our website at:
http://www.cavalrystorage.com/products/manuals/Formatting_Instructions.pdf
ENCLOSURETHE EN-CAUG ASSEMBLY GUIDE
4STEP FOUR
5STEP FIVE

EN-CAUG
4
*If you need any assistance assembling or initializing your drive within your OS, checkout CavalryStorage.com for detailed instructions.
Or, send us an email at [email protected]!
Visually inspect the seam on all 4 sides of your CAUG drive. If assembled
properly, there should be no bumps or gaps. If there are, squeeze the case
rmly until you hear the tabs engage.
Now turn your unit over, reconnect the USB cable, and check for the assigned
drive letter within “(My) Computer”. Enjoy your stylish new drive!
Place the metal cover over the plastic case. Make sure that the front side of
the metal lid is facing the same direction as the front side of the plastic case.
Carefully align the tabs along the edge of the metal cover with the channels
along the edge of the plastic cover. Press along the metal cover until it snaps
into place. Repeat this procedure carefully until all 4 tabs have snapped into
place.
ENCLOSURETHE EN-CAUG ASSEMBLY GUIDE
7STEP SEVEN
6STEP SIX