CC&C WL-6200-V3 User manual

IEEE
802.11 b/g/n
Micro 11bgn 1x1 150Mbps
Wireless Client Dongle
Model: WL-6200-V3
USER’S GUIDE
VERSION 1.2
© All rights reserved.
All trade names are registered trademarks of respective manufacturers listed.
This manual may not be copied in any media or form withou t the written consent of original maker.

Information To User ..................................................…….. I
1. Introduction .........................................................…… 1
2. Wireless LAN Basics ................................................……. 3
3. IP ADDRESS ..........................................................……. 4
4. Install Driver/Utility ...............................................……. 5
4.1 Windows XP/Vista/Win7 / 8 / 8.1............................... 5
5. Wireless Network Configuration ....................................... 7
5.1 Utility Icon ........................................................ 7
5.2 Client Mode (Default Setting)................................... 7
6. Technical Specifications ............................................... 15
7. Troubleshooting ......................................................... 16
8. Glossary ................................................................... 17

INFORMATION TO USER
Federal Communication Commission Interference Statement
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is encouraged to try to
correct the interference by one of the following measures:
* Reorient or relocate the receiving antenna.
* Increase the separation between the equipment and receiver.
* Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
* Consult the dealer or an experienced radio/TV technician for help.
REGULATION INFORMATION
The Micro 11bgn 1x1 150Mbps Wireless Client Dongle must be installed and used in strict
accordance with the manufacturer’s instructions. This device complies with the following radio
frequency and safety standards.
This device complies with Part 15 of the FCC Rules. Operation is
subject to the following two conditions:
(1) This device may not cause harmful interference.
(2) This device must accept any interference received, including
interference that may cause undesired operation.
FCC RF Radiation Exposure Statement:
The product comply with the FCC portable RF exposure limit set forth for an uncontrolled
environment and are safe for intended operation as described in this manual. The further RF
exposure reduction can be achieved if the product can be kept as far as possible from the user
body or set the device to lower output power if such function is available.
Your device contains a low power transmitter. When device is transmitted it sends out Radio
Frequency (RF) signal. Use only with supplied antenna. Unauthorized antenna, modification, or
attachments could damage the transmitter and may violate FCC regulations.
You are cautioned that changes or modifications not expressly approved by the part responsible
for compliance could void the user’s authority to operate the equipment.
The use of the USB dongle with laptops/notebooks is prohibited.

Europe- R&TTE Compliance Statement
Hereby, the company who declares that this equipment complies with the essential requirements
and other relevant provisions of DIRECTIVE 1999/5/CE OF THE EUROPEAN PARLIAMENT AND
THE COUNCIL of March 9, 1999 on radio equipment and telecommunication terminal Equipment
and the mutual recognition of their conformity (R&TTE).
CE Declaration of Conformity
For the following equipment:
Micro 11bgn 1x1 150Mbps Wireless Client Dongle
(Product Name) Micro 11bgn 1x1 150Mbps Wireless Client Dongle
(Model Designation)
is herewith confirmed to comply with the requirements set out in the Council (European
parliament) Directive on the Approximation of the Laws of the Member States relating to
Electromagnetic Compatibility of Radio and Telecom device (1999/5/EC). For the
evaluation regarding this Directive, the following standards were applied:
EN 300 328 V1.8.1
EN 301 489-1 V1.8.1 ; EN 301 489-17 V2.1.1
EN 60950-1:2006+A11:2009
This equipment is marked with the symbol and can be used throughout the European
community.
Caution: Exposure to Radio Frequency Radiation.
To comply with RF exposure compliance requirements, for mobile configurations, a separation
distance of at least 20 cm must be maintained between the antenna of this device and all persons.
This device is intended for use as check in the following European Community countries:
Austria
Belgium
Czech Republic
Cyprus
Denmark
Estonia
France
Finland
Germany
Greece
Hungary
Ireland
Italy
Iceland
Luxemburg
Latvia
Lithuania
Malta
Norway
Netherlands
Portugal
Poland
Spain
Sweden
Slovakia
Slovenia
United Kingdom

The channel identifiers, channel center frequencies, and regulatory domains of
each 22-MHz-wide channel are shown in following Table.
Channel
Identifier
Frequency
(MHZ)
Regulato r y Domains
Japan
ETSI
North
Ame r ica
Israel
Mexico
1
2412
●
●
●
2
2417
●
●
●
3
2422
●
●
●
●
4
2427
●
●
●
●
5
2432
●
●
●
●
6
2437
●
●
●
●
7
2442
●
●
●
●
8
2447
●
●
●
●
9
2452
●
●
●
●
10
2457
●
●
●
●
11
2462
●
●
●
●
12
2467
●
●
13
2472
●
●
14
2484
●

1
Thank you for your purchase of the WLAN Adapter. Featuring wireless
technology, this wireless networking solution has been designed for both
large and small businesses, and it is scalable so that you can easily add
more users and new network features depending on your business scale.
FEATURES
Support Microsoft XP(32bit/64bit) / Vista(32bit/64bit) / Win7 / 8 /
8.1(32bit/64bit).
Operating distance of up to 150 meters in free space.
150/120/90/60/54/48/36/30/24/22/18/12/11/6/5.5/2/1 Mbps selectable Data
Rate.
64/128-bit WEP , WPA (Wi-Fi Protected Access), WPA2
2.400GHz ~ 2.4835GHz unlicensed ISM Frequency Band.
Modulation Method :
IEEE 802.11b : DSSS (Direct Sequence Spread Spectrum).
IEEE 802.11g / 802.11n : OFDM (Orthogonal Frequency Division
Multiplexing). Easy operation and setting up.
SYSTEM REQUIREMENTS
Windows System : XP(32bit/64bit) / Vista(32bit/64bit) / Win7 / 8 /
8.1(32bit/64bit).
System must have a device driver installed. It allows you to
communicate with Micro 11bgn 1x1 150Mbps Wireless Client Dongle.

2
BEFORE YOU START
1. Confirm Box Contents
◆Micro 11bgn 1x1 150Mbps Wireless Client Dongle
◆Quick Start Guide
◆Driver CD
CONNECTING YOUR Micro 11bgn 1x1 150Mbps Wireless Client Dongle
Quick Start Guide
Connect your Micro 11bgn 1x1 150Mbps Wireless Client Dongle. Install
driver.
GETTING TO KNOW WIRELESS LAN ADAPTER
LED
LED turns on when WLAN link to WLAN adaptor or AP.
LED is blinking when WLAN Adapter is active.

3
Wireless LAN network defined by IEEE 802.11b/g standard committee
could be configured as :
Ad Hoc wireless LAN.
Infrastructure wireless LAN.
Ad Hoc network is a group of wireless LAN cards, this
group is called a BSS (Basic Service Set). This group can use their wireless
LAN cards to communicate with each other, but can not
connect to the Internet.
Ad Hoc Wireless Network Infrastructure Wireless Network
The most obvious difference between Infrastructure wireless network
and Ad Hoc wireless network in Infrastructure wireless network can
access the resource in the Internet through Access Point.
Depending on your requirement, you can easily set up your system
network to be a “Ad Hoc”or “Infrastructure”wireless network. Generally
speaking, if in your network, there is an Access Point in it, we recommend
you to set your network as an “Infrastructure”, so it can connect to
the Internet.

4
The installation & driver CD will automatically activate the autorun installation
program after you insert the disk into your CD drive.
Step 1 : (Win7/8/8.1 only)
Insert the installation CD into your CD-
ROM. Win7/8 UAC Dialog is shown.
Click Yes to continue.
Step 2 :
Preparing Setup dialog is shown
Step 3 :
Wizard is ready to install driver and
utility. Click Next to begin the
installation
Installing & configuring WLAN driver
and utility

5
Installing Cisco 802.1x module
Step 4 :
Click Finish to complete installation.
The installation will affect after
windows rebooting

6
Micro 11bgn 1x1 150Mbps Wireless Client Dongle uses its own management
software. All functions controlled by users are provided by this application.
When you insert the WLAN Adapter into your laptop or desktop, a icon should
appear in the Windows System Tray automatically.
5.1 Utility Icon
▓Client mode utility running but no WLAN Adapter plugged
▓Client mode utility running and WLAN Adapter scan available network.
▓Client mode utility running and WLAN Adapter can not scan any AP
5.2 Client Mode (Default Setting)
Wireless Device Control :
▓Show Tray Icon –Show icon or not show icon in system tray.
▓Radio Off –To stop wireless signal.
▓Disable Adapter –To stop wireless device.
▓Virtual WiFi allowed –To enable Soft AP

7
5.2.1 GENERAL SETTING
Once device is set,
double click on that
icon and the
configuration window
will pop up as shown. It
shows the current
connected network.
The signal strength and
link quality are
displayed also.
The bar graph displays
the quality and strength
of the link between the
node and its Access
Point. Link Quality is a measurement of receiving and transmitting
performances over the radio.
Network Address displays current MAC Address, IP Address,
Subnet. and Gateway.
Click Renew IP button to refresh IP address leased from wireless
AP.
5.2.2 PROFILE SETTING
In profile tab, you can
Add, Remove, Edit,
Duplicate and Set
Default to manipulate
profile content
manually. Strongly
recommend to use
profile after you do
Available Network.

8
5.2.3 AVAILABLE NETWOEK SETTING
Click Available
Network tab and it will
show all available
networks that radio can
reaches. Select proper
SSID & BSSID you
want to connect.
Click Refresh button to
force and rescan
available
networks currently.
Select one of SSIDs,
and click Add to
Profile to create profile
that
can be configured
more wireless
parameters.
In this page, you can
edit your profile name,
configure wireless
security like WEP,
WPA, WPA2,
802.1x …etc. After
finishing setup, click
OK button to save
configuration
5.2.4 Status
Dialog shows
Manufacture, NDIS
Driver Version, Short
Radio Header,
Encryption,
Authentication,
Channel Set, Mac
Address... etc
information

9
5.2.5 Wi-Fi Protected Setup
An easy and secure
setup solution for Wi-Fi
network. you can
choose PIN Code or
Push Button method to
connect to an AP.
▓Pin method:
Step 1 :
Press “Pin Input Config
(PIN)”button.
Step 2 :
Select a specific AP

10
Step 3 :
Enter the PIN code
into your AP.
Step 4 :
Select AP that you
want to configure.
Step 5:
Wait for configuring
your wireless AP to be
the security setting.

11
▓PBC method:
Step 1 :
Press “Push Button
Config (PBC)”button
Step 2 :
Push the physical
button on our AP or
visual button on he
WPS configuration page.

12
5.3 Virtual WiFi Setup
Step 1 :
Click “Virtual WiFi
allowed”option to
enable Virtual WiFi
configuration / status
page.
Step 2 :
Click “Start Virtual
WiFI Soft AP”option to
start
Step 3 :
Click “Config”button
to configure Soft AP
SSID and Security Key.
Step 4 :
To check “Setting Internet Connection Sharing”and “Auto Select
Public Network”options to enable ICS. If setup up Shared Network
manually, press “Apply”button to re-initialization ICS.

13

14
Symptom :
The LED is off.
Remedy :
Make sure the dongle is inserted properly. Otherwise contact your vendor.
Symptom :
The LED is always on not blinking.
Remedy :
Make sure that you have installed the driver from attached CD. Otherwise
contact your vendor.
Symptom :
The LED is blinking but the icon does not appear in your icon tray.
Remedy :
Make sure that you have installed the Utility from the attached CD.
Symptom :
The dongle is linking, but can’t share files with others.
Remedy :
Make sure the file and printer sharing function is enabled. You can
enable the function by checking the icon of My Computer -> Control
Panel -> Network -> file and printer sharing -> I want to be able to give
others to access to my files.
Symptom :
Slow or poor performance under AP mode
Remedy :
Try to select another channel for the communicating group or move your
device closer to the Access Point.

15
IEEE 802.11 Standard
The IEEE 802.11 Wireless LAN standards subcommittee, which is formulating
a standard for the industry.
Access Point
An internetworking device that seamlessly connects wired and wireless
networks together.
Ad Hoc
An Ad Hoc wireless LAN is a group of personal computers, each with a WLAN
adapter, connected as an independent wireless LAN. Ad Hoc wireless LAN
is applicable at a departmental scale for a branch or SOHO operation.
BSSID
A specific Ad Hoc LAN is called a Basic Service Set (BSS). Personal
computers in a
BSS must be configured with the same BSSID.
DHCP
Dynamic Host Configuration Protocol - a method in which IP addresses are
assigned by server dynamically to clients on the network. DHCP is used for
Dynamic IP Addressing and requires a dedicated DHCP server on the
network.
Direct Sequence Spread Spectrum
This is the method the wireless cards use to transmit data over the frequency
spectrum. The other method is frequency hopping. Direct sequence
spreads the data over one frequency range (channel) while frequency
hopping jumps from one narrow frequency band to another many
times per second.
ESSID
An Infrastructure configuration could also support roaming capability for
mobile workers. More than one BSS can be configured as an Extended
Service Set (ESS). Users within an ESS could roam freely between BSSs
while served as a continuous connection to the network wireless stations
and Access Points within an ESS must be configured with the same ESSID
and the same radio channel.
Ethernet
Ethernet is a 10/100Mbps network that runs over dedicated home/office
wiring. Users must be wired to the network at all times to gain access.
Gateway
A gateway is a hardware and software device that connects two dissimilar