CEBEK FE-103 User manual

130 mA./12V. DC.
POWER SUPPLY
FE-103
TECNHICAL CHARACTERISTICS
Input Voltage.........................................................................230V AC.
Maximum constant Output Intensity......................................130 mA at 12V DC
Maximum Ripple with loa ....................................................5 mV
Output Voltage.......................................................................12V.D.C.,(10-15V DC
Answer time against an output short-circuit (With loa )........0.3seg.
Recovering time of Vo after a short-circuit (With loa )..........1,5seg.
Fuse. .....................................................................................100mA.
Sizes......................................................................................72x53,75x30mm.
The FE-103 is a power supply completely short-circuit, inclu ing in the same boar transformer an mo ule of voltage
rectification an regulation.
It allows avoltage a justment between10 an 15 V.D.C.
It inclu es a fuse hol er an a le to in icate the operating mo e.
It can be a apte to Rail-Din ref. C-7563.
INSTALLATION
INPUT INSTALLATION : The FE-103 ha to be supplie by 230V.A.C. See the General Wiring Map. Using an a equate
plug an acable for mains connect this last one to the “INPUT” terminal 230 V.A.C. Installa fuse an a switch as it is
in icate in General Wiring Map( see hereafter). Both are necessary to protect the mo ule an for your own security, as it is
in icate in EEC regulations. Then, verify that you have correctly connecte the mo ule.
Before to connect the mo ule to the mains inserting voltage, please o the rest of connections specifie hereafter
Do not orget that in several part o the module there is voltage (230V.A.C), or this reason we suggest you to be
care ul
OUTPUT INSTALLATION Once the input installation one, verify that there is no voltage 230V. From the mains
Through the circuit ,then you can process with the output installation.
Respecting the polarety of the power supply, you have to connect it to the evice that you wish to control.
Remember that the mo ule supply a maximum of 2,4V.A. If you try to supply a evice with a consumption superior than the
power supply one,“it will fall”, ecreasing the voltage output.
Install the power supply into a metallic enclosure correctly ventilate .
NOTE : Connections in icate as 230V.A.C. in the wiring map or in the text, have to be connecte to110 V.A.C. In
Americans countries. Cebek’s Mo ules an /or transformers will be supplie with correspon ing mo ifications for their
connection in these countries.
OPERATING
OPERATING AND REGULATION MODES : Once the installation one, you coul switch on, activating the power
Supply. The Le will light to in icate that the circuit is operating. If you eactivate the power supply o there is a short-circuit,
the Le will light off.
The mo ule allows to a just the output voltage between 10 an 15V.D.C., to select the wishe value, you have to a just the
variable resistor inserte on the circuit an in icate as “ADJUST”.
FUSE REMOVE : If you have to substitute the fuse, firstly you have to eactivate the power supply. Remove the protector
an substitute it by a 100 mA fuse. Finally install again the protector
DO NOT FORGET : The power supply ha a protection against short-circuits, nevertheless the maximum time to act is 30
secon s, for this reason when this protection will be activate you have to isconnect the supplie evice an leave col the
power supply uring a minimum time of 1 minute.
www.cebek.com - [e-mail]

FE-103
GENERAL WIRING MAP
www.cebek.com - [email protected]