Celestron PowerSeeker 60 EQ User manual

Item #31132
Quick Set-up Guide
123
All three legs should be the same length to
provide a level platform for the telescope.
4
7
Locate the equatorial mount and place the
base of the mount through the hole in the
center of the tripod mounting platform.
5
Properly assembled, the accessory tray should
appear as pictured above.
6
From underneath the tripod mounting platform,
thread the attached mounting bolt into the hole
on the bottom of the equatorial mount.
8
Thread the latitude adjustment screw into the
equatorial mount until it is touching the inside
of the mount.
9
PowerSeeker 60EQ
Item# 21043
Place the accessory tray on top of the tripod's
center leg brace. Thread the tray into the
threaded hole in the center of the leg brace.
Questions or Problems with Set-up?
CONTACT:
Celestron Technical Support: 310.803.5955
Use the three tightening screws located at the
bottom of each leg to secure the extended legs
in place.
To set up the tripod, spread the legs outward
until they are fully extended and push down
center leg brace. Extend the center portion of
each of the three tripod legs down 6-8".
Your PowerSeeker 60EQ includes: optical tube;
tripod with center leg brace; equatorial mount;
latitude adjustment screw; star diagonal; 2
eyepieces; a 3x barlow lens, 1.5x erect image
eyepiece; finderscope; 5 lb. counterweight;
counterweight bar; two slow motion cables;
eyepiece accessory tray; The Sky Level 1 software,
documentation including an owner’s manual.

Quick Set-up Guide [cont]
Locate the counterweight bar and
counterweight. Slide the counterweight half
way down the counterweight bar and tighten
the wingnut to secure in place.
11
Thread the threaded end of the counterweight
bar into the Dec axis of the equatorial mount.
12
13
The longer cable should attach to the Right
Ascension axis and the shorter cable attaches
to the Declination axis -- tighten set screw to
secure in place.
14
Before mounting the tube, remove the two
wingnuts on the tube.
15
Place the tube on the mount by lining up the
screws with the mounting holes on the mount.
16
Reattach both wingnuts and tighten to secure
in place. The front of the tube should be
positioned over the counterweight assembly.
17 18
Orient the finderscope so that the glass
window is facing towards the front of the tube.
Place finderscope over the holes on the tube
and replace the knurled nuts to secure.
19 20
Insert the chrome barrel of the 20mm eyepiece
into the star diagonal and tighten the set
screw.
21
Remove the lens cap from the front of the
telescope. To observe, look through the
eyepiece as shown above.
22
For additional magnification, you can use the
included 3x barlow. Place the barlow in the
focuser in place of the eyepiece - remove the
cap from the barlow.
23
Place the eyepiece into the barlow and tighten
the set screw to secure in place.
10
Locate the finderscope and remove plastic
caps on front and back of lens. Remove the
knurled nuts at the focuser end of the
telescope tube.
Slide the chrome end of the slow motion
control cable onto equatorial mount gear shaft
and tighten set screw to secure in place.
Loosen the set screw on the focuser so that it
does not obstruct the inner diameter of the
focuser. Insert the chrome barrel star diagonal
into the focuser and tighten the set screw.
For detailed usage
information please
consult your owner’s
manual.