Cetacea Sound Ensemble 90-3 User manual

The Ensemble 90 is a professional surround sound system for presentations
to audiences. Its unique ultra light design creates a perfect sound for both voice
and multi-media presentations. This new ENS-90-3 is loud enough for a room of
90 people. Please read this instruction guide thoroughly before attempting to use
this product.
1) There are three (3) source-input plugs on the Ensemble speaker base that
can use either mono or stereo inputs depending on your “source”, i.e.,
computer, VCR, DVD, projectors, microphones, etc.
2) The Ensemble does not have an internal volume control. Use the volume
control on your source or, if required, use the in-line volume control
included in this kit. The right angle plug of the volume control must be
plugged into the “source”. Use the male-to-male extension cable to nish
the connection to one of the Ensemble inputs labeled A, B, or C. Refer to
the hook-up drawings on our web site if you have further questions.
3) If your source has a “BASS BOOST”, or special effects like Spatializer,
SRS, or controls that say “JAZZ”, “ROCK”, “BLUES”, etc., turn them off
for now!
4) Turn the volume down low before making the power connection.
5) The Ensemble speaker requires power from the Cetacea Sound Corp
approved “Power Adapter/Conditioner”. Plug the power adapter into a
suitable source of 110-220v power and the opposite small end into the
base of the Ensemble speaker. (It will only t in one location.)
6) Turn on the source and slowly turn up the volume (on both the source and
the in-line volume control). Be sure to use a high quality recording to fully
appreciate the awesome sound of the speaker. Once you are satised
with the sound, add additional sources to the other input jacks so you can
use them without changing connections every time.
READ THESE INSTRUCTIONS CLOSELY 200901-013
Ensemble 90-3
Portable Presentation Speaker
Quick Start Guide
Model #: ENS-90-3

ENSEMBLE 90-3, MODEL NO. ENS-90-3
READ THESE INSTRUCTIONS CLOSELY
Accessory Kit
Volume Control
One (1) is supplied. Use per the instructions on the other side of this guide. Take
particular note of the right angle plug. It needs to be connected to the source of
sound, i.e., computer, VCR, DVD, projector, microphones. The other end goes to the
speaker inputs labeled A, B, and C.
Stereo Line Cord
One (1) is supplied. Use between straight end of Volume Control and speaker as
an extension cable. Or, use between the audio output/headphone jack and speaker
inputs if volume control is not required.
Stereo RCA Adaptor Cable to 3.5mm Stereo
One (1) is supplied. The red and white RCA style plugs on one end and the 3.5 mm
small diameter female jack on the other end identify this cable. Use it with the Stereo
Line Cord to complete the connection to the speaker. The Volume Control can also
be used as described above. Plug the right-angle connector into the female jack of
the Stereo RCA Adapter.
NOTE: MICROPHONE INSTRUCTIONS
VERY IMPORTANT
If connecting Cetacea Sound Corp microphones into the Ensemble, use the “AUX
OUT” jack on the Receivers and the Stereo Line Cord as instructed. See separate
microphone instructions on our web site under “Products” and “Literature”.
Any further questions please see our web site for additional information, instructions,
and spec sheets.
A B C pwr
200901-013
If you have questions, call Technical Support at 800-556-1922.
www.cetaceasound.com