CG ELV User manual
CG Technology
Official tutorial
Mercedes-Benz ELV Simulator Operating Instructions
一、 Arbitrary Erase
The Mercedes-Benz ELV simulator produced by CG Technology has
convenient functions not available in other similar products. One-click
matching and manual initialization, combined with the use of CGMB-Benz
monster equipment, save time and effort, can be used multiple times, and
fully adapt to the chassis W204, The W207 and W212 Mercedes-Benz cars
can be directly replaced in the original car's directional lock position,
without being exposed, not plugged in, without affecting aesthetics, and
more stable and safe at the same time!
Wiping is divided into two methods. The premise is that communication
is required. One is software operation and the other is manual operation.
The different steps are different, but the results are the same.
Method 1: Software Operation
The first step is to connect the simulator, both the real car and the platform. As long as it can communicate, open the
software and enter the “ELV-ELV Simulator" option
Second step, click on "Erase Simulator "
Method 1: Software Operation
The third step is to clamp the yellow clip on the OBD line to the 3 pin position of the simulator
Method 1: Software Operation
The fourth step is that the reset is successful
Method 1: Software Operation
The fifth step, read the verification, the simulator password shows 0, has been activated without checking
Method 1: Software Operation
The first step is to prepare a toothpick or tweezers. Other thin objects can also be used.
Method 2: Manual Operation
The second step is to connect the simulator, insert it into the reset hole of the simulator with a toothpick or tweezers,
press it 5 times, you can hear a click, it means it has been wiped
Method 2: Manual Operation
The third step, you can enter the software to read the verification, it has been activated without checking
Method 2: Manual Operation
二、Replace The Original Car ELV
The first step is to collect the Password of the vehicle. Both the real vehicle and the platform can be used.
The second step is to save the lock data with the Password
The third step is to connect the simulator, as long as it can communicate, open the software and enter the "ELV-ELV
Simulator" option
The fourth step is to read the simulator to ensure that the simulator is inactive. If it is activated, please wipe it first.
The fifth step is to load the lock data with the key password just saved
The sixth step is to write the simulator. The prompt is successful. Please insert the key into the lock and turn on the ignition
to activate it.
Step 7. Verify that the meter and vehicle can be turned on
