Chad Valley 238/9169 User manual

Assembly Instructions -Please keep for future reference 238/9169
255/7032
Dimensions
Width - 103cm
Depth - 75cm
Height - 41cm
If you need help or have damaged or missing parts, call the Customer Helpline:
Argos = 0345 6400800
Version 1 Date: 17/10/14
Important - Please read these instructions fully before starting assembly
Playtable

1
Safety and Care Advice
Important –Please read these instructions fully before startingassembly
Note: if required the next
page can be cut out and used
as reference throughout the
assembly. Keep this page with
these instructions for future
reference.
• Check you have all the
components and tools listed on
the following pages.
• Remove all fittings from the
plastic bags and separate them
into their groups.
• Keep children and animals
away from the work area, small
parts could choke if swallowed.
• Make sure you have enough
space to layout the parts before
starting.
• During assembly do not stand
or put weight on the product,
this could cause damage.
• Assemble the item as close
to its final position (in the same
room) as possible.
• Assemble on a soft level
surface to avoid damaging the
unit or your floor.
• To reduce
the likelihood of
damaging your
product please
ensure that your
power drill is set on a low torque
setting.
• Only clean using a damp cloth
and mild detergent, do no use
bleach or abrasive cleaners.
• From time to time check that
there are no loose screws on
this unit.
• This product should not be
discarded with household waste.
Take to your local authority
waste disposal centre.
Care and maintenance
Skin contact: Remove
contamination by washing with
soap and water. This procedure
should also be followed prior to
eating and drinking.
Eye contact: Rinse immediately
with clean water for 15 minutes
and seek medical advice.
If swallowed: Seek medical
advice immediately.
Glue safety - Take care when using glue, please follow the advice below
• Assemble all parts and bolts
loosely during assembly, only
once the product is complete
should you fully tighten the bolts
• Regularly check and ensure
that all bolts and fittings are
tightend properly.
Handy Hints
• Do not use this item if any
components are missing or
damaged.
• Parts of the assembly will be
easier with 2 people.
• Argos Ltd. MK9 2 NW. • This product is intended for
children in the age range of
3-12 years.
• Maximum load: 20 kgs.
• Assembly of this product must
be carried out by a competent
adult.
IMPORTANT: RETAIN THESE INSTRUCTIONS FOR FUTURE REFERENCE
• During assembly children
should be kept away from the
product due to possible risk of
injury.

Components -Panels
Please check you have all the panels listed below
If you have damaged or missing components, call the
Customer Helpline:
Argos = 0345 6400800
2
Drawer front panel
x 4 (46 x 19.5cm)
6
Pilot holes
for guidance
only
Support panel x 3
(4.8 x 100cm)
2Front Panel x 2
(14 x 100cm)
3
Pilot holes for
guidance only
Top panel
(70 x 100cm)
1
Side panel x 2
(74.7 x 41cm)
4
Pilot holes for
guidance only
Drawer bottom side
support x 4 (46 x 4.8cm)
5
Drawer side panel
x 4 (72.7 x 22.5cm)
7
Drawer bottom panel
x 2 (46.9 x 70.3cm)
9
Drawer middle support
x 2 (46 x 4.8cm)
8

3
Please check you have all the fittings listed below
Ruler - Use this ruler to help correctly identify the screws
Tools required
Note: The quantities below are the correct amount to complete the assembly. In some cases more fittings
may be supplied than are required.
0 5 10 15 20 25 30 35 40 45 50 55 60 65 70 75 80 85 90 95 100 110 115 120 125 130 135 140 145 150 155 160 165 170
105
Components - Fittings
0 10 20 30 40 50 60 70 80 90 100 110 120 130 140 150
0 1 2 3 4 5 6
Phillips screwdriver
(medium & large)
Flatblade screwdriver
(medium)
Small
hammer
Ruler/tape
measure
Drill Eye protection
(when using a
hammer or glue)
7mm Suitable drill bit
(for use with wall plug)
The screws length is measured from the head to the point (30mm screw shown).
30mm Dowel x 43
A
39mm Locking pin x 16
B
15mm Locking nut x 16
C
50mm Screw x 24
D
Screw cover x 24
E
Castor x 8
F
14mm Screw x 16
G

B
X 3
1
2
A
A
B
B
BB
B
B
A
A
A
A
A
A
A
A
A
A
A
Attaching Top panel
4
Assembly Instructions
Step 1
a:
b:
Continued on next page.
a: Insert Dowels into
the Top panel .
A
1
Note: Insert locking pins
as far as shown.
Do not over tighten.
Screw Locking pins(6 pcs)
into the Top panel .
1
B
a: Insert Dowels into
the Support panel .
A2

C
X 2
1
3
3
C
C
CC
C
C
B
B
B
C
C
C
C
C
C
C
2
2
2
1
3
5
Assembly Instructions
Step 1 - continued
c:
d:
e:
Note: Insert locking pins
as far as shown.
Do not over tighten.
Screw Locking pins
into the Front panel .
3
B
Insert Locking nuts into
the Side panels .
3C
Use a screwdriver to turn
Locking nuts clockwise
to lock .
C
e: Position Front panel
onto the Top panel
.
1
3
c: Position Support panel
onto the Top panel
.
1
2
Insert Locking nuts into
the Support panel .
C
2
Use a screwdriver to turn
Locking nuts clockwise
to lock .
C

6
C
X 2
4
4
2
2
2
3
3
1
4
B
B
E
E
E
E
D
D
E
E
D
D
D
D
E
E
D
D
C
C
C
C
B
Use Screw covers to
cover the screw heads.
a:
Attaching Side panel
Assembly Instructions
Step 2
b:
b: Use Screws(8 pcs)
to fix the Side panel
onto the unit .
4D
Note: Insert locking pins
as far as shown.
Do not over tighten.
Screw Locking pins
into the Side panel .
4
B
Insert Locking nuts(4 pcs)
into the Top panel .
1
C
Use a screwdriver to turn
Locking nuts clockwise
to lock .
C
E

7
X 4
X 4
5
6
7
6
5
G
F
F
A
A
A
A
G
G
G
a:
b:
Continued on next page.
Assembly Instructions
Step 3
Drawers assembly
a: Insert Dowels into
the Drawer bottom side
support .
b: Position Drawer bottom
side support onto the
Drawer front panel .
6
5
Use Screws to fix the
Castors onto the
Drawer bottom side
support .
5
G
F
5
A
X 2
D
D
D
D
E
E
E
E
c:
6
c: Use Screws to fix
the Drawer side panel
onto Drawer front panel
.
7
6
D
Use Screw covers to
cover the screw heads.
E

8
d: Insert Dowels into
the Drawer middle support
.
8
A
X 2
X 2
A
A
A
A
X 2
DD
EE
DD
EE
7
6
6
9
8
d:
e:
Assembly Instructions
Step 3 - continued
f:
8
8
5
e: Carefully slide the
Drawer bottom panel
into the grooves.
9
Position Drawer middle
support
onto the unit.
8
f: Use Screws to fix the
Drawer front panel
onto the unit .
7
D
Use Screw covers to
cover the screw heads.
E

9
Assembly Instructions
Step 4
Step 4
If you need help or have damaged or missing parts, call the Customer Helpline:
Argos = 0345 6400800
Inserting drawers
Slide the assembled
drawers under the table
Assembly is complete.
Note: Before use allow
the glue to dry for 24
hours and make sure the
unit is secure.
Finishing the unit
With help, place the unit
in the intended position.