Chainway R1 User manual

Shenzhen Chainway Information Technology Co., Ltd
R1 Dual Protocol Card Sender
User Manual
Leo
25/08/2022

1
Contents
1. Appearance........................................................................................................ 2
2. Connection......................................................................................................... 2
3. Operation........................................................................................................... 2
4. Function............................................................................................................. 2
4.1 UHF Read&Write ........................................................................................ 2
4.2 HF Read&Write........................................................................................... 3
4.3 PSAM.......................................................................................................... 3
5. Settings.............................................................................................................. 4
5.1 Output Power.............................................................................................. 4
5.2 Region ........................................................................................................ 5
5.3 Buzzer......................................................................................................... 5
5.4 User Settings .............................................................................................. 5
6. UHF Infor ........................................................................................................... 6
7. Temperature ...................................................................................................... 6

2
1. Appearance
2. Connection
R1 HF/UHF card sender could be connected with PC by USB cable.
3. Operation
R1 is an HF/UHF card sender device. Its working principle is to write data information
into the tag by application. After opening the windows C# application, connect and
write data to the specified area of tag.
4. Function
4.1 UHF Read&Write
The write data function is used to write the data content of a single tag, and
write to different storage areas and different address lengths. If the tag does
not have a password, it can directly fill in the data content, and leave the
access password blank; If the password is set, please enter the correct
password to write.
The read data function is used to read the data content of a single tag, and
read different storage areas and different address lengths. If no password is
set for the tag, you can directly fill in the data content, and leave the access
password blank; If the password is set, please enter the correct password to
read.
Description of the filter option:
The filter function is used to filter out tags other than the required content and
only keep the tags of the required content during the tag identification
process. It should be noted here that filter function is implemented through
the air protocol, and other tag information will not be received by the UHF
module, so the reading performance of the tag will not be affected after
filtering.
The address bit and length are used to set the filtering details. The EPC
address starts from 32 (bit) by default, and the TID address starts from 0 (bit)

3
by default. The length needs to correspond to the data content. Since the tag
adopts hexadecimal, every 4 bits of the length corresponds to one bit of the
length. For example, if the length is set to 32 bits, the content is 8 bits, such
as 1111, 1111, and so on.
4.2 HF Read&Write
User could operate read&write function by 14443A\14443A-
CPU\14443B\15693 protocol.
4.3 PSAM
PSAM is encryption module, which selects the corresponding mode for
operation.

4
5. Settings
After connect device with PC, open exe UHFAPP and select connection mode as
USB, click open.
5.1 Output Power
The output power could select from 5-25dBm, click Set to confirm setup. Get
button could be used to check current setup parameter. Click save button
can save current settings.

5
5.2 Region
Select UHF frequencies for different countries, click Set to confirm setup.
Click Get to check current parameter, click Save to save current parameters.
5.3 Buzzer
Select Open or Close, and click set to enable or disable the buzzer. The get
button gets whether the current setting is enabled or disabled.
5.4 User Settings
Other special customization functions are configured in user setting. The
customization functions are not described here.

6
6. UHF Infor
Click UHF Infor could check current UHF firmware version.
7. Temperature
Click Temperature could check current temp. of module.

7