Champion 200966 User manual

WARNING:
Read the ENTIRE operator’s manual to become familiar with the
features of the product before operating.
Failure to operate the product correctly can result in damage to
the product, personal property and cause serious injury or even death.
200966
3500W Dual Fuel Portable Generator
quick st rt
QUICK START GUIDE

Set Up 
1.
3.
Open shipping carton. Assembly > Unpacking
5. Add oil.Assembly > Add Engine Oil.
Recommended: 10W-30, up to 20.3 fl. oz. (600 ml) DO NOT overfill.
4.
Attach wheel kit.Assembly > Install Wheel Kit
AB
×2
10W-30
A
Connect the battery. Assembly > Connect the Battery.
Cut cable tie on each side of battery connector.
Push two halves of battery connector together tightly.
AB
×2
12
2. Remove brackets.Assembly > Remove Shipping Support Brackets.

Start Up
7.
9.
10.
DO NOT plug in any electrical devices.
8.
NEVER START OR STOP THE GENERATOR WITH ELECTRICAL
DEVICES CONNECTED OR TURNED ON!
Add fuel. Assembly > Add Fuel: Gasoline
DO NOT use E15 or E85.
Connect propane cylinder.
Assembly > Add Fuel: Propane (LPG)
or / o
Select Fuel. Operation > Starting the Engine.
Gasoline: Turn fuel select dial to “Gasoline Run” position.
Propane: Turn fuel select dial to “Propane Run” position.
6. Move generator to an open, outdoor area.
Point exhaust away. Never run generator in
enclosed areas (e.g., not in house or garage).
Keep all objects at least 5 feet (1.5 m) from generator. Heat from
the muffler and exhaust gas can ignite combustible materials.
Move the generator outdoors.
Move the choke lever to the “CHOKE” position.

Start Up

Plug in.  Operation > Connecting Electrical Loads.
12.
1 2
1 2
11a. Electric Start
1. Press and hold the ignition switch to the “START” position.
2. Move the choke lever to the “RUN” position.
Gasoline
Manual Start
1. Pull the starter cord.
2. Move the choke lever to the “RUN” position.
11b. Electric Start
1. Press the ignition switch to the “START” position for 2-3 seconds.
2. Move the choke lever to the “RUN” position.
3. Press and hold the ignition switch to the “START” position.
4. If engine does not start, wait 10 seconds, then repeat step 3.
Propane
Manual Start
1. Pull the starter cord 2-3 times until you feel some combustion pulses.
2. Move the choke lever to the “RUN” position.
3. Pull the starter cord.
1
1
2
2
3
3
Learn more about generators we have.