
BACK OF TV
ANT IN
OUTSIDE
INSIDE
Power Outlet
< DC Power
Supply
IN OUT
PREAMP
BACK OF TV
ANT IN
BACK OF TV
ANT IN
IN
OUT
OUT
OUT
OUT
Cable Coaxial >
CM-3706
< Note: Length depends on installation
< Cable Coaxial
< Preamplifier
< Balun
300 to 75 Ohm Matching Transformer
CM-94444
Mast >
Power Inserter
4-Way RF Splitter
Power Passing >
TO
TV TO
AMP
TO
POWER
BACK OF TV
ANT IN
BACK OF TV
ANT IN
BACK OF TV
ANT IN
BACK OF TV
ANT IN
/OUTPOWER
IN OUT OUT OUT
INPOWER IN
Power Inserter >
Power Inserter >
(Option 2)
(Option 1)
TO
TV TO
AMP
TO
POWER
TO
AMP TO
TV
TO
POWER
Power Outlet
DC Power >
Supply
DC Power >
Supply
Distribution
Amplifier >
CM-3414
Installation Diagrams 7 TVs with Amp
ChannelMaster.com | 877.746.7261
1
4
5
3
6
7
Installation:
1. Use a coaxial cable to connect the
Antenna to the “Antenna In” port on the
Pre as shown in the image.
4. Use a separate coaxial cable to
connect the “RF Out/DC Power IN” port
on the splitter to the “To Amp” port on
the Power Inserter.
3. Use separate coaxial cables to connect
the “To TV” ports on the splitter to 3 TVs
in your home.
5. Use a separate coaxial cable to
connect the “To TV” port on the power
inserter to the “RF IN” port on the
distribution
7. Use separate coaxial cables to connect
the “To TV” ports on the distribution
to the TVs in your home.
2a
2b
2. A) Use a separate coaxial cable
to connect the “Out” port on the
to the “Antenna IN/DC
Power Out” port on the splitter.
B) Optional Location for the Power
Inserter. If used here then a regular non
power passing splitter will be OK.
6. Two options to power the distribution
(Option 1 - When Power source is close
to distribution Use a separate
coaxial cable to connect the “Power
IN” port on the distribution to
the DC power supply. Plug in the DC
power supply into power outlet.
(Option 2 - When NO power source is
close to Distribution Use a
separate coaxial cable to connect the
“Power IN/Out” port on the distribution
to the “To Amp” port on the
power inserter. Use a separate coaxial
cable to connect the “To TV” port on
the power inserter to the “ANT IN” port
on the TV. Use a separate coaxial cable
to connect the DC power supply to the
power inserter. Plug in the DC power
supply into power outlet.
© 2021 Channel Master L.L.C. Channel Master is a registered trademark. Specifications subject to change. All rights reserved. © 2021 Channel Master. Channel Master es una marca registrada. Especificaciones sujetas a
cambio. Todos los derechos reservados. © Channel Master, 2021. Channel Master est une marque déposée. Les caractéristiques peuvent être modifiées sans préavis. Tous droits réservés. Pub CM7778HD.IS.202101
CM-7777/CM-7778/CM-7777HD
CM-7777V3/CM-7778V3/CM7778HD
CM-1805
CM-7777XPI
v
CM-7777XPI
CM-7777XPI