CHAT BOARD DYNAMIC WOOD ACOUSTIC User manual

ASSEMBLY INSTRUCTIONS
DYNAMIC
WOOD ACOUSTIC
SHELF
DESIGN BY CLAUS BRANDT JAKOBSEN

GET STARTED
2
NB
Please note that assembling Dynamic is a job for at least two people

PARTS
3
1 x solid wood frame
2 x powder coated aluminium feet
4 x caster wheels
and
4 x steel pins
2 x metal track
4 x mounting magnets (with washers)
6 x powder coated aluminium shelf supports
3 x powder coated aluminium shelves
2 x bottom panels with solid wood lamellas
2 x glass board on a steel frame
A
B
C
F
I
D
E
A
B
C
D
E
F
G
G
H
H
I

INCLUDED SCREWS, BOLTS ETC.
4
I
4 x M8 x 70 mm bolts
- for mounting the feet to the frame
II
4 x M8 hexagon nuts
- for mounting the feet to the frame
8 x spring washers
- for mounting the feet to the frame
III
IV
4 x M4 x 40 mm screws
- for mounting the magnets to the frame
V
8 x M4 x 20 mm screws
- for mounting the metal tracks to the frame
VII
4 x plastic distancers
- to help place the lamella panels correctly
VI
12 x M3.5 x 20 mm screws
- for mounting the shelf supports to the frame

1.
5
Start by assembling the wheels and steel pins , before attaching these to the aluminium feet .
Then, place the wooden frame on an elevated, at surface, such as a large table.
Mount the feet (now with wheels) to the bottom, using the provided bolts , nuts and spring washers .
CB
A
I II III
x 4

2.
6
Carefully lift the frame off the surface and place in an upright position.

3.
7
(Repeat on both sides)
Fasten the metal track to the top of the frame with 4 x screws, using the four pre-drilled holes.
Then fasten the two mounting magnets to the bottom of the frame, as indicated below, using the washers
and screws.
D
E
V
E
E
D
V
V
V
V
IV

4.
8
Fasten the 6 shelf supports into the matching hollows on the sides of the frame, using the 12 x screws.
F
F
F
F
F
F
F
F
VI

5.
9
(Repeat on both sides)
Mount two lamella panels at the bottom of the frame, using the plastic distancers as guides to ensure
that they are perfectly centred within the lower part of the frame, both horizontally and vertically.
TIP The velcro system means that this can be easily redone if needed.
I
Next, mount the glass boards onto the frame, by simply sus-
pending them from the installed metal tracks and pushing them
into the frame, until the two mounting magnets on each side of
the frame “catch” the steel back plate.
H
H
I
VII

6.
10
Finally, mount the three shelves onto the shelf supports.
And you’re all done.
G
G
G
G
G

CHAT BOARD®
designed & manufactured
by CHAT BOARD A/S
Tempovej 10 C
DK-2750 Ballerup
T. [phone]
F. [phone]
inf[email protected]
www.chat-board.dk
VAT no. DK 15806230