CHAT BOARD DYNAMIC WOOD ACOUSTIC FULL COVERAGE User manual

ASSEMBLY INSTRUCTIONS
DYNAMIC
WOOD ACOUSTIC
FULL COVERAGE
DESIGN BY CLAUS BRANDT JAKOBSEN

GET STARTED
2
NB
Please note that assembling Dynamic is a job for at least two people

PARTS
3
1 x solid wood frame
2 x powder coated aluminium feet
4 x caster wheels
and
4 x steel pins
1 x metal track
3 x mounting magnets (with washers)
1 x back panel with solid wood lamellas
1 x front panel with solid wood lamellas
1 x glass board on a steel frame
A
B
C
F
G
H
D
E
A
B
C
D
E
F
G
H

INCLUDED SCREWS, BOLTS ETC.
4
I
4 x M8 x 70 mm bolts
- for mounting the feet to the frame
II
4 x M8 hexagon nuts
- for mounting the feet to the frame
8 x spring washers
- for mounting the feet to the frame
III
4 x M4 x 60 mm screws
- for mounting the large lamella panel to the
frame (top and middle)
IV
V
2 x M4 x 40 mm screws
- 2 for mounting the large lamella panel to
the frame (bottom)
- 3 for mounting the magnets to the frame
VI
4 x M4 x 20 mm screws
- for mounting the metal track to the frame
VII
4 x plastic distancers
- to help place the lamella panels correctly

1.
5
Start by assembling the wheels and steel pins , before attaching these to the aluminium feet .
Then, place the wooden frame on an elevated, at surface, such as a large table.
Mount the feet (now with wheels) to the bottom, using the provided bolts , nuts and spring washers .
CB
A
I II III
x 4

2.
6
Making sure that the front of the frame is facing up, lay down the metal track at the top of the frame.
It is important that this is perfectly centred.
Fasten the metal track to four of the pre-drilled holes indicated here, using 4 x screws.
D
Fasten the three mounting magnets , as indicated below, using the washers and 3 x screws.
E
VI
VI
VI
VI
VI
E
E
E
D
V

3.
7
Carefully lift the frame off the surface and place in an upright position.

4.
8
Fasten the large lamella back panel onto the back, using 2 x screws at the top of the frame (going in
from the other side, through the metal track as indicated below).
Use 2 of the same screws through the centre beam of the frame.
TIP Use the plastic distancers to ensure that the lamellas don’t touch the bottom of the frame.
Finally, screw 2 x screws into the bottom beam, located right over the bottom metal beam.
FIV
VII
IV
IV
IV
IV
V
V
V
IV
IV IV
IV IV
V V
F

5.
9
Mount the smaller lamella front panel , using the plastic distancers as guides to ensure that it is perfect-
ly centred within the lower part of the frame, both horizontally and vertically.
TIP The velcro system means that this can be easily redone if needed.
H
Finally, mount the glass board onto the front of the frame, by
simply suspending it from the installed metal track and pushing it
into the frame, until the three mounting magnets “catch” the steel
back plate.
G
G
H
VII

CHAT BOARD®
designed & manufactured
by CHAT BOARD A/S
Tempovej 10 C
DK-2750 Ballerup
T. [phone]
F. [phone]
inf[email protected]
www.chat-board.dk
VAT no. DK 15806230