Introduction
Congratulations on the purchase of your new CHAUVET Snow Machine. We are
confident you will enjoy many trouble free hours with this unit. To assist with the care
and use of the product we have prepared this short guide.
Operation
Before plugging in this unit, you must first fill the fluid tank with snow fluid.
This unit has been designed to operate on 120v-50/60Hz or 220v/50Hz.
Place the machine on a level surface and loosen the cap of the fluid tank to fill with
quality water based snow fluid. We recommend the use of CHAUVET snow fluid as it
has been specially formulated for use with the CHAUVET snow machine.
This unit has been designed to operate via the included wired remote control or via
the “Manual Button” on the rear of the unit. To operate via remote control, plug the
remote control into the socket at the rear of the unit. Depress button on remote to
disperse snow. If manual dispersion is desired, depress “Manual Button” on rear of
unit to disperse snow. Snow will continue to disperse as long as button is depressed.
Installation/Mounting
The snow machine must be used in a horizontal position sitting on a level surface.
Take care not to aim directly into anyone’s face.
Cleaning
Unplug unit before attempting to clean.
After every 40 hours of continuous operation or when the machine will be idle for a
long period of time it is recommended to run a cleaning solution composed of distilled
water through the system to prevent the accumulation of particles.
1. While unit is unplugged, remove sock and clean with mild soap and water.
Allow sock to dry completely before reattaching to unit.
2. Empty all snow fluid from the machine and replace with distilled water. Plug
unit in and depress Manual Button at the rear of the unit. Run in a well
ventilated area until tank is empty.
3. Replace clean sock.
4. Clean the body of the unit with a soft damp cloth.
5. Unplug and refill with CHAUVET snow fluid.(refill immediately before use)
A well maintained machine will provide years of reliable use.
Replacing Fuses
In the event that the unit does not function when plugged in, then it is likely that the
fuse has blown.
Unplug unit before attempting to replace the fuse.
In order to replace the fuse, unscrew the Fuseholder Cap to reveal the fuse. The unit
has a label attached which indicates the correct fuse rating or you may refer to the
Technical Specifications section in this guide. It is most important that replacement
fuses are of the correct rating. Failure to use the correct fuse could damage the unit
beyond economic repair.
The fuse should simply be placed inside the holder and the screw cap replaced.
Maintenance & Servicing
Do not allow snow fluid to become contaminated.
Work on internal parts should be carried out by a qualified technician. Removal of any
covers is considered a breach of warranty and will not be covered under any such
agreement unless authorized by CHAUVET.
Fluid Tank
Handle
Nozzle
At the rear:
Screw Cap
Fuseholder
Manual snow button
Remote control socket
