Chemglass CLS-1380-SAR1 User manual
Assembly Instructions
for Applikon®Agitator to
Sartorius®Motor Adapter
Part No. CLS-1380-SAR1
Contact Us
T 1.800.843.1794 F 1.800.922.4361
[email protected] www.cglifesciences.com
Trademarks are the property of their respective owners. Printed in USA. CG-20040IH0420
Contact Us
T 1.800.843.1794 F 1.800.922.4361
[email protected] www.cglifesciences.com
Component Parts
1Agitator Top Adapter Plate
2 Socket-Head Cap Screws
3Shaft Adapter
4 Set Screws
5 Agitator Housing Cap
6 Agitator Spline Gear
7 Flat-Head Cap Screws
Completed Assembly
Part No. CLS-1380-SAR1
Adapter comes partially assembled as
shown at left.
Step 1: Disassemble the adapter using the
supplied 2.5mm Allen wrench as shown.
Step 2: Using the 2.5mm Allen wrench, remove
the 4 top screws from the agitator assembly.
Step 3: Using a small crescent wrench (not
supplied), remove the 4 extension legs from the
agitator assembly.
CAUTION: Agitator top is now loose. ASAP,
please install lower adapter as shown in Step 4.
Step 4: Using a 3mm
Allen wrench, attach
the housing cap using
the 4 socket head cap
screws.
Step 5: Using a 2.5mm Allen wrench, slide the
shaft adapter over the pin and tighten.
Step 6: Using a 2.5mm Allen wrench, attach
the housing cap to the lower plate using the
enclosed screws.
Step 7: Position spline gear approximately
5mm above the adapter plate and tighten with a
2.5mm Allen screw.
5mm
