The climate controls include the follow-
ing functions:
(Fan): Turn the fan control knob (A)
to increase or decrease fan speed.
Turn the fan knob to the (Off)
position to turn off the system.
(Air Conditioning): Press this
button to turn the air conditioning system
on or off.
(Recirculation): Press this button
to recirculate inside air through the vehi-
cle and keep outside air from entering
the vehicle. The recirculation mode will
operate only when the vent or bi-level
mode is selected.
9
The power outside rearview mirrors can
be adjusted using the controls located
on the driver’s door.
Use the bottom switch to select the
driver-side or passenger-side mirror; and
then use the control pad to adjust the
selected mirror up, down or side to side.
Move the selector switch to the center
position when not adjusting either mirror.
See Section 2 of your Owner Manual.
Power Mirror Controls
Climate Controls
(Outside Air): Press this button to
allow outside air to enter the vehicle.
Temperature Control: Rotate the
thumbwheels (B) to raise or lower the
temperature setting(s) for the driver and
front passenger zones.
Airflow Modes: Turn the airflow control
knob (C) to change the direction of the
air delivery to the vent, bi-level, floor,
defog, or defrost mode. The knob can
be positioned between two modes for a
wide range of airflow adjustments.
(Rear Window Defogger): Press
this button to activate the rear window
defogger. The defogger will turn off
automatically after about 10 minutes.
Maximum Cooling Performance
1. Open the windows to let the hot
inside air escape; then close them.
2. Select the lowest temperature setting
for both zones.
3. Select the (Vent) mode.
4. Press the (Air Conditioning)
button.
5. Select the highest fan speed.
Maximum Heating Performance
1. Select the highest temperature setting
for both zones.
2. Select the (Floor) mode.
3. Select a mid-level fan speed.
4. When airflow feels warm, select the
highest fan speed.
See Section 3 of your Owner Manual.
BAC
Note: When the lowest temperature set-
ting and the air conditioning are selected,
the recirculation mode is automatically
activated. If a higher temperature setting
is selected later, the system will change
to the outside air mode.
Note: A flashing light when the air
conditioning or recirculation button is
pressed indicates that the function is not
available based on the current settings
or the outside temperature.
