CHI Air Spin n Curl Installation and user guide

90
0
1. Choose your desired temperature and curling timer
as a guide (15S/17S/19S).
2. Hold the CHI Spin n Curl vertically with the digital
control side facing the head.
3. Take a ¾” to 1” section of hair and insert it into the
opening of the curl chamber in a 90° angle. If
larger sections are used, hair may be tangled.
4. Insert sectioned hair into the curling chamber. 5. Press and continuously hold the arrow button in the
desired direction to curl the hair. The hair strand
will be automatically curled into the chamber and
the rotating will stop.
Beep . . .
6. You will hear 4 beeps once the curl is set. 7. Remove the tool gently from the hair.
How to style with

1. Clean the surface of the Spin n Curl with a damp
cloth.
2. Turn on the Spin n Curl by pressing the power
button.
3. Insert the barrel cleaner into the curling
chamber in correct position below.
4. Press the left or right arrow buttons to
automatically remove residue. For safety
purposes, the Spin n Curl stops heating up
when the cleaning function is active.
5. Recommend cleaning the Spin n Curl once
a week
• Use a smaller section of hair for defined curls.
• Use a larger section of hair for less defined curls.
• If hair becomes tangled, the Spin n Curl will beep continuously and the display will read RESET.
Push the power button on the Spin n Curl to turn off and gently remove the tangled hair by pulling out
thin strands, section by section, until all the hair has been removed.
Cleaning
Tips