installation.
lf the keyboard and receiver have lost auto-recognition,
please pair the lD Codes by the following steps.
1, Paring the keyboard and the receiver
Press the lD button on the receiver and the
indicator on the receiver will flash;
Press the lD button at the bottom of the keyboard;
lf the indicator on the receiver stops flashing, the
paring between the keyboard and the receiver
has been successful.
(Please refer to Figure 3)
+
+
II
Figure 3
:::t.iii:i.'lttxli,ii0Hilg]sliqcs!! |::r:::ii:i:i.:i:r,, r:...::..
Problem Solution
The buttons are not
working properly.
Please change the battenes.
If you do not use the
keyboard for 8
minutes, the first click
to the keyboard will be
trealed as a wafte up
instruction, therefore,
no response for input
by this first click.
From the second click, the
keyboard will be responding
properly.
The keyboard is not in
sleep mode and there
is no response from
the keyboard
Please follow the "Paring
keyboard with the receiver"
in part 3 of this user
manual.
The keyboard does not
response properly, or
response very slowly;
Please change the batterres.
The low power
indicator light on the
Please change the batteries.
Page 4Page 5
