ChocoVision REVOLATION 1 User manual

REVOLATION 1

Assembly
Note: To avoid damage to your scraper it is recommended that your bowl/scraper be
“primed” for the first few uses. To do so, take a small piece of - chocolate, and simply rub it
on the inside of the bowl. This will insure a smooth initial start up.
Place the Bowl in your machine and
rotate the bowl until it drops into place
Attach the scraper to the baffle. When
properly installed, the scraper should
curve towards the front of the machine

Assembly (Baffle to Bowl)
Fit the baffle into the bowl by rotating
the baffle clockwise until the baffle
connector pins engage into baffle lock

Assembly (Baffle Clip)
Slide the baffle clip on to the baffle.
This keeps the solid chocolate from
climbing out of the bowl as it
rotates

The Controls
READY MODE INDICATOR- When illuminated
the chocolate is tempered and ready to use
CHOCOLATE TYPE—LED
indicators scroll from one
chocolate type to another during
depression of the “S” button.
Release “S” button when desired
chocolate type is illuminated.
SEED IN/TEMPER- Select to start the tempering cycle.
Add “SEED” chocolate when flashing.
RESET—Stops the machine and resets the
controls.
SELECT BUTTON- Sets the machine for the desired chocolate type
when pressed and held down. Once released, the MELT cycle is
started. Select “S” again to begin the TEMPER cycle (after the
SEED IN light flashes).

Operating the Machine
Load up to 1.5lbs at a time Hold down the ‘S’ button to select
the chocolate type.

Seeding the Chocolate
When the seed in/Temper light is
flashing add at least 4 oz of solid,
tempered chocolate(SEED)behind
the baffle and press the “S” button
You will hear three beeps and
READY MODE INDICATOR
illuminates. Remove remaining
‘Seed’ at this time. Chocolate is
ready to use
“SEED” chocolate. This is solid tempered chocolate that has the proper crystalline structure.
To dramatically improve on tempering time, “seed chocolate is slowly added to untempered
chocolate. There should ALWAYS be “SEED” to be taken out when the machine indicates that the
chocolate is ready to be used.

Final Phase

Tips and Useful Hints
The Chocolate Thickens:
The chocolate may have picked up moisture from dipping fresh fruits, or from high
room humidity.
The chocolate was left in the Temper mode too long.
The “seed” chocolate was not removed on time, causing the tempered pool to thicken.
You can simply press the melt button and start over using these tips:
Never allow water to mix with melted chocolate. Make sure all items being dipped
into the tempered chocolate are at room temperature, and COMPLETELY DRY,
including all utensils being used.
Ideal room temperature should be between 20-22 C (68-72F), with the humidity not
above 50%
Moving large volumes of air across the product helps in the cooling process