CIE AVID3AC-WS4 User manual

Registered in England No. 2761780
CIE-Group Ltd 3 Widdowson Close Blenheim Ind Est Bulwell Nottingham NG6 8WB UK
T: [phone] F: [phone] E: [email protected]om W: www.cie-group.com
01/18
www.cie-group.com
IR Remote Control Function:
Using the supplied IR Remote Control will give access to further features and functions of the AVID3AC
and will allow adjustments to the sound levels and tone settings.
The LED display panel will show the settings as any adjustments are made as follows:
• Theoverallvolumelevel(0lowest~20highest)
• Bass(L.1lowest~L.9highest)
• Treble(H.1lowest~H.9highest)
• Balance(B.1FullyLe~B.5Centre~B.9FullyRight)
Aeranychangeshavebeenmadetotheabove,theLEDdisplaywillreverttothesetvolumelevel.
PleaseensurethattheenclosedUserInstructionsarelewiththeAVID3ACunit,easilyavailabletothe
end user.
Bass Level
Control
Treble Level
Control
Volume Level
Control
Power
ON/OFF
L/R Speaker
Balance
Function not enabled
on AVID3BT Model
Before installation please take the time to read and understand the enclosed information.
What’s included in the box?
1xAVID3ACAmplifier
1xIRRemoteControlUnit&WallBracket
1x2-GangEORecessedBackbox
Installation Guide
Specifications:
Output Power 2 x 15W @ 4W
Line Inputs Stereo 3.5mm Jack (Front panel)
2x Screw Terminal (Rear PCB)
Line Output Fixed level (Unbalanced) 1v 47kW
Frequency Response 40Hz ~ 20KHz
Input Sensitivity (Lo) 200mv / (Hi) 1v
Power Requirements 230v AC
Dimensions 165(W) x 100(H) x 35(D) mm
Weight 0.26kg

Rear Panel Controls and Connectivity:
ScrewterminalconnectionsforACPower,AUXWiredInputs,LoudspeakerOutputsandLineLeveloutputs
are located on the rear PCB of the AVID3.
TheAVID3ACispoweredviaafused230vACoutlet.
The two wired AUX input terminal on the rear are configured for a Stereo Input Signal; the three-way
connectorhasterminalsforL(LeSignal),G(Screen)andR(RightSignal).
Important Information:
It is important to note that if using the audio input located on the rear of the AVID3AC that the signal
applied is at full line level.
Whenusingthisapplicationanappropriatescreenedcableisrequiredtoreducethepossibilityofexternal
signal interference.
Note.ThewiredinputAUX1terminalisinparallelwiththe3.5mmJackInputonthefrontpanel;ifeither
inputsareconnectedandasignalispresentonboth,thenthetwosourceswillbemixedtogether(This
shouldbeclearlyexplainedtotheuser).
AjumperisprovidedtoallowtheAVID3ACtobeusedineithermonoorstereomode,thefactorydefaultis
stereo.Ifsettomonotheamplifierwillprovideamixedoutputtoeachloudspeakerterminal.
LoudspeakersshouldbewiredtotheL+L-andR+R-terminals,ensuringthephaseofeachloudspeaker
is the same.
Thelineoutputisstereoandprovidesafixedlineoutputsignalforfeedingandexternalsourcesuchasa
slave amplifier or induction loop system.
Ifyouare experiencing any problems pleasecontactyour reseller or the CIE-GroupTechnical Support
Departmenton+44(0)1159770075.
Fascia
Trim
Plate
Hi/Lo Line
Level
Sensitivity
Switch
IR
Receiver
Window
Audio Level
& Input
Selection
Display
Volume
Level
Up
Volume
Level
Down
ON/OFF
Switch/
Input Select
3.5mm
Jack
Input
Introduction:
BeforeinstallationpleaseremovetheFaciaTrimPlatefromaroundthefrontedgeoftheunit.Thiscanbe
refitted once the installation is finished and any decorating is completed.
ThecompactdepthoftheAVID3ACunitwillallowinstallationintostandardUK2-gangEOboxes,witha
minimumof40mmdepth.AplasticEOboxisnowincludedforrecessedinstallation.
Thesemaybegalvanisedmetalforinstallationinsolidconstructionwalls,plasticdrylining(withlugs)or
maybeinstalledintosurfacemountingDado-typetrunkingsystemsusingtheappropriatefixings.
Front Panel Controls and Connectivity:
3 illuminated buttons allow basic control of the AVID3, the bottom button (     ) controls the ON/OFF
function,theup/downbuttons()controlVolumeUpandVolumeDown.
Selection of which output is being broadcast is made by short pressing the ON/OFF Switch, S1/S2 is
displayed in the display to show which input is in use.
AStereo3.5mmjackinputisprovidedonthefrontpanel,twofurtherhardwiredAUXinputsareprovided
to the rear of the AVID3AC.
TheHi/Loswitchadjuststheinputsensitivityfrom1v(LineLevel)to200mv(averageHeadphoneoutput
level),allowingtheinterfaceofgenericMP3,CDandmediaplayerswithoutlossofsystemvolumelevel.
AclearLCDDisplayshowsthedesiredvolumelevelbetween0(nooutput)to20(maximumoutput)aswell
asshowingwhichinputisinuse(S1/S2).
Loudspeaker
Balance
Trim Pots
Line Output
Wired Input/AUX1
Wired
Input/
AUX2
Mono / Stereo
Jumper Selector
Loudspeaker
Outputs
AC MAINS
Input