cinetto Wave Sensor Operating manual
Quik use guide
2
English
All dimensions in this leaflet are stated in
millimeters.
WARNING
Do not use any anti-friction oil or grease or
thread-realese spray on ball bearing or on
wheels with O-ring, it can cause the mel-
ting of the inside ball bearing grease, ma-
king them noisy or causing the break of the
O-ring of the wheels.
ABBREVIATIONS
W width
WA door width
L length
LB rail length
D depth
H height
I distance between centres
T thickness
S overlapping
The pictures and descriptions this leaflet con-
tains are supplied for information purposes.
The company reserves the right to introduce
those modifications it deems opportune for
any construction or commercial need at any
time and without advance notice.
3
Before installing Wave Sensor, it is necessary to have installed the
B-moved electrical system.
PS40.3
11
A
CONFIGURATION
4
1 4
E
32
F
CONFIGURATION
CONFIGURATION
5
122
1
B
PS48.2
CONFIGURATION
6
1 3
2
C
*Central door opening just to the left.
CONFIGURATION
7
1 4
2 3
D
CONFIGURATION
8
Wireless proximity sensor
Up to 10 sensors each
door.
Max recommended distance between receiver unit and sensor:
10 meters.
Battey not included.
2 x AAA 1,5V for each sensor.
9
Wave Sensor positioning
3821
71,5
23
option
MAX 10 MAX 10 MAX 10
Do not place Wave Sensor behind metallic, conductive materials or mirrors.
102
68,5 5
10
00:00:02
1. Pairing
To start the procedure, press and hold the button for the channel you want to configure (“SENSOR SET A” or “SENSOR
SET B”) for two seconds, the corresponding LED will start to flash.
2. Reset
To reset a channel, press and hold the corresponding button for 10 seconds. The LED will start to flash and then remain
steady for two seconds. Once it stops flashing, the reset procedure is completed and it will be possible to pair again
to the channel up to a maximum of 10 sensors.
11
Touch the sensor you want to pair, this will be immediately recognised, causing the LED to flash quickly twice before
turning off. At this point the procedure is completed and the devices are correctly paired.
• Up to 10 different sensors can be paired with each channel.
• The receiver remains in the “pairing” phase for 30 seconds. If no sensor is touched during this time, the
procedure is blocked.
• If you try to pair a sensor already paired to the channel, the LED will flash quickly twice and then block
the procedure.
• If nothing happens, this means that either there is a system malfunction or the maximum number of sensors
that can be paired with the channel has been reached. Try resetting the channel (see point 2) and repeat
the pairing.
1st edition - OCTOBER 2019
Cinetto F.lli S.r.l.
Via Rossi, 5/A
35030 Rubano (PD) Italy
Tel.
+39 049 8977211
Fax +39 049 635822
www.cinetto.it
Other cinetto Accessories manuals
