Cisco B200 M3 User manual

Americas Headquarters:
Cisco Systems, Inc., 170 West Tasman Drive, San Jose, CA 95134-1706 USA
Cisco B200 M3 Blade Server
Statement of Volatility
Publication Date: November 19, 2013
The Cisco B200 M3 blade server has multiple serial, electrically erasable, and programmable nonvolatile
memory components (EEPROM and Flash memory) that are used to store manufacturing hardware
identification and hardware configuration information. The majority of serial EEPROMs and flash
memories are not written by users and contain no customer information. Procedures for clearing the few
flash devices that can retain customer data are included in this document.
•Restoring the BIOS to the Factory Default Settings
•Restoring the LSI SAS Controller to the Factory Default Settings
•Restoring the CIMC to the Factory Default Settings
•Resetting the CMOS From UCS Manager
Restoring the BIOS to the Factory Default Settings
Use the following procedure to restore the BIOS to the factory default settings through the UCS Manager
remote KVM or a local KVM I/O cable that is connected directly to the blade server.
Step 1 Press F2 to access the BIOS setup.
Step 2 Click the Save and Exit tab.
Step 3 On the Save and Exit tab, click Load Default Values.
Step 4 Click Yes.
Step 5 Click Save and Exit or press F10.
Step 6 Click Yes to reboot the blade server.

2
Cisco B200 M3 Blade Server Statement of Volatility
Restoring the LSI SAS Controller to the Factory Default Settings
Restoring the LSI SAS Controller to the Factory Default Settings
Use the following procedure to restore the LSI SAS controller to the factory default settings through the
UCS Manager remote KVM or a local KVM I/O cable that is connected directly to the blade server.
Step 1 Press Ctrl-H to log on to the web GUI.
Step 2 Click Start.
Step 3 Click the Controller Properties tab.
Step 4 Click Next.
Step 5 Click Set Factory Defaults.
Step 6 Click Yes.
Step 7 Click Submit.
Step 8 Press Ctrl-Alt-Delete to reboot the blade server.
Restoring the CIMC to the Factory Default Settings
Use the following procedure to restore the Cisco Integrated Management Controller (CIMC) to the
factory default settings.
Step 1 Shut down the blade server to power it down.
Step 2 Remove the blade server from the chassis for 30 seconds or longer to turn off the standby power.
Step 3 Insert the blade server back into the chassis to power it on, which will automatically reboot the CIMC
and restore it to its factory default settings.
Resetting the CMOS From UCS Manager
Use the following procedure to reset the CMOS from UCS Manager.
Step 1 In the UCS Manager navigation window, click the Equipment tab.
Step 2 On the Equipment tab, choose Equipment > Chassis > Chassis Number > Servers.
Step 3 Choose the server on which you want to reset the CMOS.
Step 4 In the Work pane, click the General tab.
Step 5 In the Actions area, click Recover Server.
Step 6 In the Recover Server dialog box, click Reset CMOS and then click OK.