clare CS-PIN-10 User manual

The CS-PIN-10 is a simple arming station that allows
local control of the security system. It is battery
powered and requires no installation tools. Many
can be installed throughout the home to provide
convenient system control.
Features
• Secure 4 to 10 digit disarming
• Supports 1-button arming
• Small yet comfortable
Enroll by placing the panel into wireless enrollment
mode and then sending an enrollment signal from the
PINPad. Alternatively, the PINPad can be enrolled by
scanning its bar code using the install Assist App.
Option for sending an Enrollment Signal
• Press 1and 3buttons simultaneously
Install using the 3M VHB® tape on the back of the
PINPad to adhere it to a wall.
• See Pro Tips for recommendations about using
3M VHB tape.
• Two #4 or #6 screws may be used instead of,
or in addition to, the 3M VHB tape.
• The mounting plate can also be rotated 180°
for table top use (See Pro Tips).
Operate using the PINPad buttons. The PINPad LED
will blink when a button is activated.
Disarm by entering a valid 4-10 digit user code on
the number pad.
Arm Away by pressing the AWAY button until the
PINPad LED ashes red.
Arm Stay by pressing the STAY button until the
PINPad LED ashes red.
Trigger a panic alarm by pressing the STAY &
AWAY buttons together until the Red PINPad LED
ashes repeatedly.
Use the panel installation guide to verify proper system setup.
Enrollment Buttons
Arm Stay Arm Away
LED
Mounting Screw Holes
VHB Tape
VHB Tape
I
N
S
T
A
L
L
G
U
I
D
E
I
CS-PIN-10
Wireless Pinpad

Pro Tips
3M VHB Tape works great if the surface is properly prepared and rm pressure is applied
for over 10 seconds.
Surface Preparation
• Clean the surface
• Ensure the mounting surface temperature is above 50 °F
Reversible mounting plate allows for easy use on a wall or table. For table top use,
remove and reverse the mounting plate and install the rubber feet supplied.
To replace the battery insert a screwdriver into the latch slot on either side of the
PINPad and pop the cover off the wall plate. Replace the battery and reinstall the
cover onto the wall plate.
Specications
Physical
Housing Dimensions
Weight with Battery
Mounting Fastener
2.28 x 1.97 x 0.40 inches (5.8 x 5.0 x 1.0 cm)
0.70 ounces (20 grams)
3M VHB™ Tape or #4/#6 screws (Mounting screws not provided)
Environmental
Operating Temperature
Maximum Humidity
32 to 120 °F (0 to 49 °C)
85% relative humidity non-condensing
Sensor Specications
Frequency
Replacement Battery
Nominal Battery Life
Battery Voltage
Current Draw
Transmitted Indications
433.92 MHz
One Panasonic CR2032
4 to 6 years
3.0 VDC (Nominal), 2.2 VDC (Low)
20 mA (Maximum), 1 uA (Quiescent)
Low Battery, Supervision
Certication
RE652
RE652-CE
UL634, ULC634, FCC, IC
EN50131-1, EN 60950-1, EN300 220, EN301 489, CE, RCM
Specications subject to change without notice.
01
2019-02-1838-01
941.238.3991
www.ClareControls.com
Original document below
https://bit.ly/2IBUzHe