Clarion DRB4675 User manual

| Owner’s manual...
Clarion
@ Contents
1. PRECAUTIONS .......... se ahha dak Dae Coa ce ako aea 2
3. BUTTON TERMINOLOGY ...0000.. ce eccteeeeereereteeee 4
4, FEATURES: fs vorcieisce eerste cis uanenateeeataoanias retinas 5
5. HANDLING COMPACT DISCS............ Su Secanwasuenteedalis 6
6. DCP (Detachable Control Panel)............0.....0....08 7
7. REMOTE CONTROLL (DRB4675 and RDB465D)....8
B; OPERATION. yossisGeccesicretvechap sce teacibextetvetvstntasctonrdeacd: 10
9. TROUBLESHOOTING ...0ooo. cee eeeerseeeeee 14
10.ERROR DISPLAYS............ sgaatuedd Sul deasuceueerseshors wasuancs 15
11. SPECIFIGATIONGS...........:.:cccccccssesscsenserscecessssecererene 1
AM/FM CD PLAYER
COMPACT
DIGITAL AUDIO
oe be j
ee ee oe
eam) fi fe ts Hata te On 0" O-]|

1. PRECAUTIONS
1. When the inside of the car is very cold and
the player is used soon after switching on
the heater, moisture may form on the disc
or the optical parts of the player and proper
playback may not be possible. If morsture
forms on the disc, wipe it off with a soft
cloth. If moisture forms on the optical parts
of the player, do not use the player for
about one hour and the condensation will
disappear naturally to allow normal opera-
tion.
2. Driving on extremely bumpy roads which
cause severe vibration may cause the
sound to skip.
3. This unit uses a precision mechanism.
Even in the event that trouble arises, never
open the case, disassemble the unit, or
lubricate the rotating parts.
This equipment has been tested and found to
comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reason-
able protection against harmfu! interference in
a residential installation. This equipment gen-
erates, uses, and can radiate radio frequency
energy and, if not installed and used in accor-
dance with the instructions, may cause harmful
interference to radio communications.
However, there is no guarantee that interfer-
ence will not occur in a particular installation. If
this equipment does cause harmful interfer-
ence to radio or television reception, which can
be determined by turning the equipment off
and on, the user is encouraged to consult the
dealer or an experienced radio/TV technician
for help.
USE OF CONTROLS, ADJUSTMENTS, OR PERFORMANCE OF PROCEDURES OTHER 1 THAN
THOSE SPECIFIED HEREIN, MAY RESULT IN HAZARDOUS RADIATION EXPOSURE.
THE COMPACT DISC PLAYER SHOULD NOT BE ADJUSTED OR REPAIRED BY ANYONE
EXCEPT PROPERLY QUALIFIED SERVICE PERSONNEL.
Bottom View of Source Unit
INFORMATION FOR USERS:
MODEL - Clarion
V © GROUN
AM 530-17 10kHiZ/FM 87. 1 07.9MHz
THIS DEVICE COMPLIES WITH PAAT 15 OF THE FCC RULES.
OPERATION 'S SUBJECT TO TRE FOLLOWING TWO CONDITIONS:
(1) THIS DEVICE MAY NOT CAUSE HARMFUL INTERFERENCE, AND
{2} THIS DEVICE MUST ACCEPT ANY INTERFERENCE RECEIVED,
per penrd INTERFERENCE THAT MAY CAUSE UNOESIAED
OPERA
THIS PRODUCTION COMPLIES WITH DHHS RULES 21 CFR
SUBCHAPTER J APPLICABLE AT DATE OF MANUFACTURE.
EN a ere rr
CLARION CO.,LTD.
50 KAMITODA, TODA-SHI,SAITAMA-KEN, JAPAN
CHANGES OR MODIFICATIONS TO THIS PRODUCT WILL VOID THE WARRANTY AND
WILL VIOLATE FCC APPROVAL.
Be sure to unfold and read the next page.
Cerciérese de desplegar y de leer la pagina siguiente.
DRB4675/DRB3675/RDB4650/ROB365D Z

2. CONTROLS
Note: Be sure to unfold this page and refer to the front diagrams as you read each chapter.
SOURCE UNIT
CD Insertion Siot
9] 18} (7) [6
DISPLAY
123)
SCN RPT ROM
Note: The above illustration shows the front panel of the model DRB4675.
ORB4675/0R83675/RD8465D/RD8365D

3. BUTTON TERMINOLOGY
Note:
e Be sure to read this chapter referring to the front diagrams of chapter 2. CONTROLS on page 3 (unfold).
[1] DCP Release Button
[2] A-M (Audio Mode) Button
LD (Loudness) Button
POWER Button
FNC (Function) Button
[o>]
Eject (44) Button
DISP (Display) Button
fo f& &
ISR (Instant Station Recall) Button
[I]
RDM (Random) Button
RPT (Repeat) Button
[o]
SCN (Scan) Button
PS/AS (Preset Scan/Auto Store) Button
Preset Buttons (1 to 6)
[=]
Z-EHCR (Z-enhancer) Button
[s]
BND (Band) Button
TOP (Top Play) Button
je
SRCH (Search) Left and Right (<€ and >) Buttons
[=]
Rotary Knob
(15) Play/Pause ( »/II) Button
MUTE Button
4 OR84675/0RB3675/R084650/RDB36SD

4. FEATURES
Rotary Encoder Volume Control
DIN Chassis with Detachable Control Panel
Z-Enhancer with 3 Mode Sound Selector
M@GI-TUNE® FM Reception System
AM/FM Bands-1 AM, 3 FM/18 FM/6 AM Touchbutton Memory
8-Times Oversampling Digital Filter and Dual 1-Bit D/A Converters
Zero-Bit Detector™ Mute Circuit
Repeat/Random Play/intro Music Scan
Multi-Color LC Display
2-Channel RCA Line Level Output with Fader Control (DRB3675 and RDB365D)
4-Channel RCA Line Level Output with Fader Control (DRB4675 and RDB465D)
180 W (45 W x 4) Maximum Power Output
Infrared Remote Control (This function is only for DRB4675 and RDB465D.)
DRB4675/0RB83675/ROB4650/RD8365D 5

5. HANDLING COMPACT DISCS
This unit has been designed specifically for play- Note on Compact Discs
back of compact discs ae the GG mark. Never stick labels on the surface of the compact
No other discs can be played. disc or mark the surface with a pencil or pen.
To remove the compact disc from its storage
case, press down on the center of the case and
lift the disc out, holding it carefully by the edges.
Removing the disc Proper way to hold
the compact disc
Do not use any solvents such as commercially
available cleaners, anti-static spray, or thinner to
Always handle the compact disc by the edges. clean compact discs.
Never touch the surface.
To remove fingermarks and dust, use a soft
cloth, and wipe in a straight line from the center
of the compact disc to the circumference.
Do not use compact discs that have large
scratches, are misshapen, or cracked, etc. Use
of such discs will cause misoperation or damage.
New discs may have some roughness around
the edges. The unit may not work or the sound
may skip if such discs are used. Use a ball-point
pen, etc. to remove roughness from the edge of
the disc.
Do not expose compact discs to direct sunlight
or any heat source.
Note:
e Do not use commercially available CD protection sheets or discs equipped with stabilizers, etc. These
may get caught in the internal mechanism and damage the disc.
6 DRB4575/DRB3875/RDB465D/RD8365D

The control panel can be detached to prevent
theft. When detaching the control panel, store it
in the included DCP case to prevent scratches.
We recommend taking the detachable control
panel with you when feaving the car.
Removing the DCP
1. Turn off the power.
2. Press the DCP Release button [1].
*« The DCP is unlocked.
3. Remove the DCP.
Attaching the DCP
Insert the DCP into the right side of the source
unit and press the left side to lock it.
Do not insert the DCP
may damage it.
Storing the DCP in the DCP Case
Hold the DCP, in the orientation as shown in the
figure below, and put it into the supplied DCP
case. (Ensure the DCP is in the correct orienta-
tion.)
6. DCP (Detachable Control Panel)
* The DCP can easily be damaged by shocks. After
removing it, place it in a protective case and be
careful not to drop it or subject it to strong shocks.
« When the release button is pressed and the DCP is
unlocked, the car’s vibrations may cause it to fall.
To prevent damage to the DCP, always store it ina
protective case after detaching it.
e The rear connector that connects the source unit
and the DCP is an extremely important part. Be
careful not to damage it by pressing on it with fin-
gernails, pens, screwdrivers, etc.
DCP Rear Panel Source Unit Front
DCP
connector
Source unit connector
Note:
e if the DCP is dirty, wipe off with a soft, dry cloth only.
DRB4675/0R83675/RDB4650/RD8365B 7

yy
bi CE cel
i (a) aa3,
Sa) ooo
Operating range: 30° in all directions
Remote Control Unit
Clarion
Inserting the Batteries
1. Turn the remote control unit over, then slide
the rear cover in the direction of the arrow.
2. Insert the AA (UM-3/1.5 V) batteries that
came with the remote control unit facing in
the directions shown in the figure, then close
the rear cover.
Notes:
Using batteries improperly can cause them to explode.
Take note of the following points:
® When replacing batteries, replace both batteries with
new ones.
® Do not short-circuit, disassemble or heat batteries.
® Do not dispose of batteries into fire or flames.
® Dispose of spent batteries properly.
8 0RB4575/0R83675/RDB465D/RDB365D
1m bt
--—= Signal transmitter
Note:
Rear side
7. REMOTE CONTROL (DRB4675 and RDB465D)
Receiver for remote control unit
e The remote control function is only available
on the DRB4675 and RDB465D.
The remote control function is not provided
with the DRB3675 and RDB365D.
AA (UM-3/1.5 V)
Batteries
Rear cover

Functions of Remote Control Unit Buttons
FUNC
BAND
DISC UP
PROG
TOP
VOLUME increases and decreases volume (in all modes}.
Turns power on and off. When pressed and held for 1 second: Turns power off.
Switches between radio and CD.
Plays the first track.
Top play.
Switches reception band.
SEARCH Moves preset channels up and down. Moves tracks up and down.
Switches between playback and pause.
ISR Recalls ISR radio station in memory.
(radio mode only).
25] RPT No function. Repeat play.
BLS
When pressed and held for 1 second:
Fast-forward/fast-backward.
20} PLAY/PAUSE | Turns mute on and off.
[2i] MUTE Turns mute on and off. Switches between playback and pause.
Press and hold for more than 2 seconds: Stores current station into [SR memory
23} DISP Switches among main display, sub display and clock display.
SCAN Preset scan. Scan play.
PS/AS When pressed and held for 2 seconds:
Auto store.
ai
* Some of the corresponding buttons on the source unit and remote contro! unit have different functions.
DRB4675/DRB3675/RDB4650/RDB365D 9

8. OPERATION
Note:
e Be sure to read this chapter referring to the front diagrams of chapter 2. CONTROLS on page 3 (unfold).
Basic Operations
$644 ey Sent
When this unit is turned on, starting and stop-
ping the engine of a car with its volume raised
to the maximum jevel may harm your hearing.
Be careful about adjusting the volume.
Turning ON the Power and Adjusting
the Volume
1) Press the POWER button [3].
* To turn off the power, press the POWER button
[3] for 1 second or longer.
2) Press the FNC button [3] and select another
operation mode. Every time the FNC button
[3] is pressed, the display changes the oper-
ation mode as:
Radio ~ CD => Radio
Notes:
° The operation mode not connected to the unit will not
be selected.
e if the CD mode is selected when no disc is inserted,
the display flashes “DISC”.
3) Turning the Rotary knob clockwise
increases the volume; turning it counterclock-
wise decreases the volume.
* The volume level is from 0 (minimum) to 33 (max-
imum).
Audio Mode Adjustments
Press the A-M button [2] to select the adjustment
mode. The mode switches as follows each time
the A-M button is pressed:
BASS + TREB ~ BAL ~ FAD > Previous
mode
Adjusting the Bass
1) Press A-M button [2] and select “BASS”.
2) Turning the Rotary knob [14] clockwise empha-
sizes the bass; turning it counterclockwise
attenuates the bass.
* The factory default setting is “0”. (Adjustment
range: ~6 to +6)
3} When the adjusiment is complete, press A-M
button [2] several times until the function
mode is reached.
10 ORB4675/DRB3675/ROB465D0/RD8365D
Adjusting the Treble
1) Press A-M button [2] and select “TREB”.
2) Turning the Rotary knob [14] clockwise empha-
sizes the treble; turning it counterclockwise
attenuates the treble.
*The factory default setting is “O”. (Adjustment
range: —6 to +6)
3) When the adjustment is compiete, press A-M
button [2] several times until the function
mode is reached.
Adjusting the Balance
1) Press A-M button [2] and select “BAL”.
2) Turning the Rotary knob [14] clockwise empha-
sizes the sound from the right speaker; turn-
ing it counterclockwise emphasizes the sound
from the left speaker.
* The factory default setting is “0”. (Adjustment
range: LO to RQ)
3} When the adjustment is complete, press A-M
button [2] several times until the function
mode is reached.
Adjusting the Fader
1) Press A-M button [2] and select “FAD”.
2) Turning the Rotary knob [14] clockwise empha-
sizes the sound from the front speakers; turn-
ing it counterclockwise emphasizes the sound
from the rear speakers.
* The factory default setting is “0”. (Adjustment
range: F9 to R$)
3) When the adjustment is complete, press A-M
button [2] several times until the function
mode is reached.