Clark Synthesis Aquasonic Isolation Transformer User manual

303-797-7500
www.clarksynthesis.com
1. Place the Isolation Transformer in a
dry, indoor, location. e transformer
is not designed to be mounted
outdoors.
4. Locate the speaker cable from the
amplier. Remove .75 in. (20 mm) of
the cable’s outer jacket.
7. Insert the positive wire (usually
white or red) to the 1+ terminal, and
the negative wire (usually black) to the
1- connection. Tighten the 1+ and 1-
screws.
2. Transformer may be mounted to
a wall using mounting tabs. (e
transformer is heavy and must be
securely mounted to the wall.)
5. Remove .3 in. (8 mm) of insulation
from each wire.
8. Push the gray ring down until it
locks on the connector’s body.
3. Locate the Neutrik NL3FC Speakon
connector. Remove the connector
from the bag.
6. Place the Speakon connector’s blue
bushing on the amplier cable.
9. Screw the blue bushing onto the
connector’s body. e connector is
now assembled.

Isolation Transformer
Installation Guide
303-797-7500
www.clarksynthesis.com
10. Plug the amplier cable connector into the transformer input. Make sure to turn the connector until it locks in place.
11. Repeat steps 3 - 9 to attach the Speakon connector to the Diluvio Speaker cable. Connect the positive wire (white) to
the 1+ connection, and the negative wire (black) to the 1- connection.
12. Plug the Diluvio Speaker cable connector into the transformer output. Make sure to turn the connector until it locks
in place.