Clarke CGR1 User manual

USER INSTRUCTIONS
GC01/10
GARAGE RACK
Model CGR1
Part No 7628904

2
INTRODUCTION
Thank you for purchasing this CLARKE Garage Rack.
Before attempting to use this product, it is essential that you read this manual
thoroughly and carefully follow all instructions given. In doing so you will
ensure the safety of yourself and that of others around you, and you can also
look forward to the product giving you long and satisfactory service.
GUARANTEE
This CLARKE product is guaranteed against faulty manufacture for a period of
12 months from the date of purchase. Please keep your receipt as proof of
purchase. This guarantee is invalid if the product is found to have been
abused or tampered with in any way, or not used for its intended purpose.
Faulty goods should be returned to their place of purchase, no product can
be returned to us without prior permission. This guarantee does not effect
your statutory rights.
ENVIRONMENTAL PROTECTION
Do not dispose of this product with general household waste. All tools,
accessories and packaging should be sorted, taken to a recycling
centre and disposed of appropriately.
TECHNICAL SPECIFICATIONS
PRODUCT SPECIFICATION
Product weight 6.8 kg
Max width 3300 mm
Min width 1900 mm
Max load capacity 120 kg (evenly distributed over both rails)
CONTENTS
2 x frames
8 x 10 mm dia wall plugs
8 x 90 mm screws

3
SAFETY PRECAUTIONS
NEVER load the rack with more than the maximum permitted working load.
ENSURE that the rack is installed in a location strong enough to take the
combined weight of the rack and whatever is being stored on it. (max 120kg)
ALWAYS check for damage before use. Any damage should be properly
repaired or the part replaced. If in doubt, DO NOT use. Consult your dealer.
ENSURE that the weight is evenly distributed across the full width of the rack
rather than in one place, especially the centre.
ALWAYS keep storage area tidy. Cluttered areas invite accidents.
ALWAYS ensure that adequate lighting is available and well positioned.
NEVER swing or climb on the garage rack.
ALWAYS fix the rack to a solid masonry wall able to take the load of 120kg.
USER INSTRUCTIONS
Install the rack using the fixing screws provided.
1. Mark the positions of the fixing holes accurately on the wall.
2. Use a hammer drill with an 10 mm bit to create holes for the wall plugs.
3. Extend the rack to suit the width between the walls and secure in place
with the fixing screws provided. The frames can be adjusted to any width
between 1900 and 3300 mm.
4. Always distribute any heavy loads evenly across the rack.