CLEAN MEDS CM001 User manual

Pulse Oximeter

Insert the Loop Of the lanyard
into the lanyard holes.
Thread the lanyard strap
through the loop.
Pull the lanyard strap until it is
Tight secured.

It Instructed to install
batteries in opposite
polarities as illustrated,
inspite of the springs
beings oddly located on the
same side.

Oxygen Saturation
SP02>95%
N
Normal Healthy Individual
SPO2 91%-95%
N
Clinically acceptable, but low.
Patient may be a smoker, or be
unhealthy.
SP02 70%-90%
Y
Hypoxemia. Unhealthy and
unsafe level.
SPO2<70%
Y
Extreme lack of oxygen, ischemic
diseases may occur. The Clean
Meds Oximeter is not calibrated
to detect readings lower than
70%.

Resting Pulse Rate
PR <40 BPM
Y
Below healthy resting heart rates
Clean Meds of does not detect
pulse rates lower than 30BMP.
PR 40-60 BPM
Y/N
Resting heart rate for sleeping.
PR 60-100 BPM
N
Healthy adult resting heartrate.
PR 100 BPM –
220 BPM
Y
Acceptable if measured during
exercise. Not acceptable if
resting heartrate.
PR > 220 BPM
Y
Abnormally high heart rate. The
Clean Meds does not detect
heart rates > 254 BPM.

About OLED Screen :-The using OLED are known as
OLED. The display of OLED screen has two Glass
substrates enclosing a layer of liquid crystal. The is
placed between these electrodes.The liquid crystal
molecules align in different patterns.
PCB Function with Pulse Oximeter:-The pulse
oximeter analyses the light absorption of two
wavelengths from the pulsatile-added volume of
oxygenated arterial blood (AC/DC) and calculates
the absorption ratio using the following equation.
SpO2 is taken out from a table stored on the
memory calculated with empirical formulas.

Oximeter CM001
2xAAA Duracell Battery’s
Pouch Bag
Lanyard
User Manual

Note:
If the product is defective/damaged, it will come under the policy of
repair.
If The Product Condition is good, It comes under a policy of replacement.