cleer SCENE User manual

SCENE
QUICK START GUIDE

SCENE QUICK START GUIDE
Top
Front
Front light lndicator
Short press:
Mic off
2
1
Playback:
Play / Pause
Call:
Pick / Hang up call
Short press:
Volume up
Long Press:
Next track
Short press:
Volume down
Long Press:
Previous track

SCENE QUICK START GUIDE
Rear
3
Connections
Aux In
Open the cover to plug in 3.5mm
audio jack for line in or TYPE-C
charging cable for charging.
Power
4
1s
> 2s
ON
OFF
Short press:
Bluetooth pairing

SCENE QUICK START GUIDE
Bluetooth pairing

SCENE QUICK START GUIDE
Phone call
5
Press Play to pick up / hang up
a phone call.
Then talk to the
mic.

SCENE QUICK START GUIDE
LED behavior
6
Blinking Steady
NA
Power On
Speaker
connected
NA
NA
NA
Bluetooth
pairing
NA
Front light indicator
Charging mode
Charging
0-99%
Charging complete

SCENE QUICK START GUIDE
Warnings
Do not push the
speaker passive
radiator during
audio playback.
7
Specifications
• Driver size: 2PCS 48mm x 48mm dynamic driver
• Frequency response: 20Hz-20KHz
• Connections: TYPE-C cable for charging
• Support: BT 5.0, A2DP v1.3, AVRCP v1.6 , HFP
v1.7, HSP v1.2.
• Bluetooth transmitter frequency range: 2.402-
2.480GHz
• Bluetooth transmitter power: <4dBm
• Bluetooth transmitter modulation: GFSK, π/4
DQPSK, 8DPSK
• Battery type: rechargeable lithium ion
cylindrical cell (7.4V, 2600mAh)
8

SCENE QUICK START GUIDE
Cleer Limited Warranty
Cleer Limited warrants this product against defects in
material or workmanship for (1) year as set forth below
when purchased directly from Cleer Limited or a Cleer
Limited retailer. Pursuant to this Limited Warranty, Cleer
Limited will, at its option, (i) repair the product using new
or refurbished parts or (ii) replace the product with a
new or refurbished product. For purposes of this Limited
Warranty, “refurbished” means a product or part that has
been returned to its original specifications. In the event
of a defect, these are your exclusive remedies.
Labor: For a period of (1) year from the original date
of purchase of the product (“Labor Warranty”), Cleer
Limited will, at its option, repair or replace with new
or refurbished product, product determined to be
defective. If Cleer Limited elects to replace the product
after this Labor Warranty has expired but while the parts
labor charge.
Parts: For a period of (1) year from the original date of
purchase of the product (“Parts Warranty”), Cleer Limited
will supply new or refurbished replacement parts in
exchange for parts determined to be defective.
This Limited Warranty covers only the hardware
components packaged with the Product. It does not
cover technical assistance for hardware or software
usage and it does not cover any software products
whether or not contained in the Product; any such
software is provided “AS IS” unless expressly provided
for in any enclosed software Limited Warranty. Please
refer to the End User License Agreements included with
the Product for your rights and obligations with respect
to the software.
Instructions: To obtain warranty service, you must
deliver the Product, freight prepaid, in either its original
protection to the original Cleer Limited retailer (point of
purchase) or Cleer Limited Customer Service. It is your

SCENE QUICK START GUIDE
responsibility to backup any data, software or other
materials you may have stored or preserved on your
unit. It is unlikely that such data, software or other
materials will be lost or reformatted during service
and Cleer Limited will not be responsible for any
such damage or loss. A dated purchase receipt from
Cleer Limited or a Cleer Limited retailer is required. For
specific instructions on how to obtain warranty service
for your product,
Visit the Cleer Limited website: www.cleeraudio.com
Following warranty service your original Product or a
replacement Product will be returned to you as your
Product was configured when originally purchased.
Repair / Replacement Warranty: This Limited
Warranty shall apply to any repair, replacement part or
replacement product for the remainder of the original
Limited Warranty period or for (90) days, whichever is
longer. Any parts or product replaced under this Limited
Warranty will become property of Cleer Limited
This Limited Warranty shall not apply to: (a) consumable
parts, such as batteries that are designed to diminish
over time, unless failure has occurred due to a defect
in materials or workmanship; (b) cosmetic damage,
including but not limited to scratches, dents and broken
plastic on ports; (c) defects caused by normal wear
and tear or otherwise due to the normal aging of the
device; (d) damage caused by accident, negligence,
abuse, misuse, fire, earthquakes, acts of God or damage
resulting from liquid outside of the approved levels; (e)
damage caused by operating the device outside Cleer
Limited published guidelines; (f) damage caused by
service performed by anyone who is not a representative
of Cleer Limited or a Cleer Limited authorized service
provider; (g) Products whose seals are tampered; (h)
Products whose serial numbers have been removed or
defaced from such Product; (i) modifications, alterations
or repairs to the Product made by a party other than
Cleer Limited or a party authorized by Cleer Limited; (j)
any failure by End User or a third party to comply with

SCENE QUICK START GUIDE
environmental and storage requirements for the Product
specified by Cleer Limited, including, without limitation,
temperature or humidity ranges; or (k) use of the Product
in combination with any third-party devices or products
that have not been provided or recommended by Cleer
Limited.
LIMITATION ON DAMAGES: CLEER LIMITED
SHALL NOT BE LIABLE FOR ANY INCIDENTAL OR
CONSEQUENTIAL DAMAGES FOR BREACH OF ANY
EXPRESS OR IMPLIED WARRANTY ON THIS PRODUCT.
DURATION OF IMPLIED WARRANTIES: EXCEPT
TO THE EXTENT PROHIBITED BY APPLICABLE LAW,
ANY IMPLIED WARRANTY OF MERCHANTABILITY
OR FITNESS FOR A PARTICULAR PURPOSE ON THIS
PRODUCT IS LIMITED TO THE DURATION OF THIS
WARRANTY.
DISCLAIMER: THE LIMITED WARRANTY SET FORTH
HEREIN IS EXCLUSIVE AND IN LIEU OF ALL OTHER
WARRANTIES OR CONDITIONS RELATING TO
THE PRODUCT, WHETHER EXPRESS OR IMPLIED,
AND CLEER LIMITED EXPRESSLY DISCLAIMS ALL
OTHER WARRANTIES AND CONDITIONS WHETHER
EXPRESS, IMPLIED OR STATUTORY, INCLUDING
ANY IMPLIED WARRANTIES OF MERCHANTABILITY,
NON-INFRINGEMENT, FITNESS FOR A PARTICULAR
PURPOSE, AND ANY WARRANTIES ARISING OUT
OF COURSE OF DEALING OR USAGE OF TRADE
AND AGAINST HIDDEN DEFECTS, TO THE FULLEST
EXTENT PERMITTED BY LAW. CLEER LIMITED DOES
NOT WARRANT THAT THE PRODUCT WILL MEET
CUSTOMER’S REQUIREMENTS OR THAT USE OF
THE PRODUCT WILL BE UNINTERRUPTED OR ERROR
FREE. NO ADVICE OR INFORMATION, WHETHER
ORAL OR WRITTEN, OBTAINED FROM CLEER LIMITED
OR ELSEWHERE WILL CREATE ANY WARRANTY NOT
EXPRESSLY STATED IN THIS WARRANTY.

SCENE QUICK START GUIDE
Compliance with FCC rules
1. This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference.
(2) This device must accept any interference
received, including interference that may cause
undesired operation.
2. Changes or modifications not expressly approved
by the party responsible for compliance could void the
user’s authority to operate the equipment.
NOTE: This equipment has been tested and found
to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against
harmful interference in a residential installation.
This equipment generates uses and can radiate
radio frequency energy and, if not installed and used
in accordance with the instructions, may cause harmful
interference to radio communications. However, there
is no guarantee that interference will not occur in a
particular installation. If this equipment does cause
harmful interference to radio or television reception,
which can be determined by turning the equipment
interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the
equipment andreceiver.
• Connect the equipment into an outlet on a
is connected.
• Consult the dealer or an experienced radio/TV
technician for help.
Radiation Exposure Statement:
This equipment complies with FCC radiation exposure
requirement. The device can be used in portable
exposure condition without RF restriction.

SCENE QUICK START GUIDE
NOTICE
Recycling
Your product is designed and manufactured with high quality
materials and components, which can be recycled and reused.
When you see the crossed out wheel bin symbol attached to a
product, it means the product is covered by the European Directive
2002/96 EC:
Never dispose of your product with other household waste.
Please inform yourself about the local rules on the separate
collection of electrical and electronic products. The correct
disposal of your old product helps prevent potentially negative
consequences on the environment and human health. Your
product contains batteries covered by the European Directive
2006/66/EC, which cannot be disposed of with normal
household waste.
The device complies with RF specifications when the device used
compliance with essential requirements and other relevant provisions of
Directive 2014/53/EU.

SCENE QUICK START GUIDE
IMPORTANT SAFETY INSTRUCTIONS
Please readand keep all the safety andoperation instructions.
General Safety Information
• To prevent possible hearing damage, do not listen at high levels
for longperiods.
• This product contains small parts which may be a chocking
hazard. Not suitable for children under age 3.
• This product contains magnetic material. Consult your physician
• Risk of explosion if battery is replaced by an incorrect type.
Dispose of used batteries accordingto the instructions.
• Leaving the product in hot or cold places will reduce the capacity
and lifetime of the battery. Always try to keep the battery between
-20C° and 40C°.A product with a hot or cold battery may not work
temporarily, even when the battery is fully charged.
• Use caution and follow applicable laws regarding mobile phone
and headphone use if using the headphones for phone calls while
driving.
• Focus on your safety and that of others if you use the headphones
while engaging in any activity requiring your attention. You may
remove the headphones or adjust your volume to ensure you can
hear surrounding sounds, including alarms and warning signals.
• Do not use the headphones if they emit any loud unusual noise.
If this happens, put the headphones back the charge case and
contact Cleer customer service.
• Do not submerge or expose the headphones for extended
period to water, or wear while participating in water sports, e.g.,
swimming, surfing, etc.

SCENE QUICK START GUIDE
©2022 Cleer Limited. All rights reserved
The Bluetooth® word mark and logos are registered trademarks
owned by Bluetooth SIG, Inc. and any use of such marks by Cleer
Limited, Incorporated is under license. Other trademarks and
trade names are those of their respective owners. Made in China
02
Register your product andget support at
www.cleeraudio.com

FCC Warning
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
Any Changes or modifications not expressly approved by the party responsible for compliance could
void the user's authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates uses and can radiate
radio frequency energy and, if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help.
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment.
This equipment should be installed and operated with minimum distance 20cm between the radiator &
your body.