Clover VDP1300 User manual

2
3
1
4
5
6
7
8
910
11
Front view
LOCK
AC120V
Rear view
R1 Video output
R2 Ground
R3 Audio signal
R4 DC 13V – 14V

1. Handset 6. Monitor Button
Lift to communicate
with your visitors.
Press this button to view the picture from
the camera
2. 4” flat CRT 7. Call Button (intercom function)
Press this button to communicate with
monitor 2 or monitor 3
3. Power Lamp
(Green) 8. Door Release Button
Indicate if the system
is on or off
Release the door to let your visitors
come in after viewing them
4. Operation Lamp
(Green) 9. Volume
Light on indicates
operating Adjustment of the call sound volume
5. Speaker 10. Brightness
Broadcasts the voice
from the visitor Adjustment for image brightness
11. Contrast
Adjustment for image contrast
OUTDOOR CAMERA
1
2
3
4
5
2
3
1
4
5
6
7
8
910
11

Rearview
Connector pin configuration
R1 Video output
R2 Ground
R3 Audio signal
R4 DC 13V – 14V
1. Super infrared LEDs
Let you see clearly even at night
2. Microphone
Picks up the voice of the visitors
3. Speaker 4. Camera
Broadcasts the voice from the monitor Picks up the image of the visitors clearly
5. Call button
Chime “ding dong” sound can be heard from
inter-phone when this button is pressed, and
the camera start working simultaneously

HOW TO INSTALL
INSTALLATION OF MONITOR
1.Attach the bracket to the wall, wherever you want to install the monitor. Secure the bracket with the
supplied screws.
2.Connect the cable connectors with 4 wires in polarity to the wafer on the rear of the monitor.
3.Fasten the monitor onto the bracket
4.Connect the spring wire of handset
5.Plug the supplied 1AAC adapter to the DC IN jack on the rear of the monitor and plug it into AC 120V outlet.
1. INSTALLATION OF CAMERA
40
87
100
113
NO.3
140
95
NO.2
Di
g
Size : m m

3
NO.1:ON WALL NO.2:IN WALL NO.3:ON DOOR
1. Attach the bracket to the wall, wherever you want to install the camera. Secure the bracket with the
supplied screws (Refer to the above illustration).
2. Connect the cable connectors with 4 wires in polarity to the wafer on the rear of the camera.
3. Fasten the camera onto the bracket