Clover Mini 3 User manual

Mini 3
Quick Start Guide
Kurzanleitung / Instructions de démarrage / Guía de inicio rápido
Guida introduttiva / Snelstartgids
clover.com/help

1
2
3

Plug in last, to a grounded AC power outlet.
Brancher en dernier sur une prise de courant
alternatif (CA) mise à la terre.
Zuletzt einstecken.
Enchufe al último.
Collegare per ultimo.
Sluit als laatste aan.
4
5
6

FCC Part 15
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, (2) This device must accept
any interference received, including interference that may cause undesired operation.
FCC Part 15 Class B-speciic
Note: This equipment has been tested and found to comply with the limits for a Class B dig-
ital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide rea-
sonable protection against harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television reception, which can
be determined by turning the equipment o and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit dierent from that to which the
receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
FCC Warning
Changes or modiications not expressly approved by the party responsible for compliance
could void the user‘s authority to operate the equipment.
FCC exposure limit compliance statement (SAR statement)
This equipment complies with radio frequency (RF) exposure limits adopted by the Federal
Communications Commission for an uncontrolled environment. This equipment should be
installed and operated with minimum distance 20 cm between the radiator & your body.

Innovation, Science and Economic Development Canada (ISED) statement:
CAN ICES-3 (B)/NMB-3(B)
This device complies with ISED’s license-exempt RSSs. Operation is subject to the following
two conditions:
(1) this device may not cause interference, and
(2) this device must accept any interference, including interference that may cause
undesired operation of the device.
Le présent appareil est conforme aux CNR d’Industrie Canada applicables aux appareils
radio exempts de licence. L’exploitation est autorisée aux deux conditions suivantes:
(1) l’appareil ne doit pas produire de brouillage, et
(2) l’utilisateur de l’appareil doit accepter tout brouillage radioélectrique subi, même si le
brouillage est susceptible d’en compromettre le fonctionnement.
The device could automatically discontinue transmission in case of absence of information to
transmit, or operational failure. Note that this is not intended to prohibit transmission of con-
trol or signaling information or the use of repetitive codes where required by the technology.
• The device for operation in the band 5150–5250 MHz is only for indoor use to reduce the
potential for harmful interference to co-channel mobile satellite systems;
• The maximum antenna gain permitted for devices in the bands 5250–5350 MHz and
5470–5725 MHz shall comply with the e.i.r.p. limit; an
• The maximum antenna gain permitted for devices in the band 5725–5825 MHz shall
comply with the e.i.r.p. limits speciied for point-to-point and non point-to-point
operation as appropriate.
In addition, high-power radars are allocated as primary users (i.e. priority users) of the bands
5250–5350 MHz and 5650–5850 MHz and that these radars could cause interference and/
or damage to LE-LAN devices.
L’appareil pourrait automatiquement interrompre la transmission s’il n’y a aucune informa-
tion à transmettre ou en cas de panne fonctionnelle. À noter que l’objectif de cette disposi-

tion n’est pas d’empêcher la transmission d’informations de contrôle ou de signalisation, ou
encore l’utilisation de codes répétitifs exigés par la technique.
• L’appareil fonctionnant dans la bande comprise entre 5150 et 5250MHz est
uniquement réservé à une utilisation en intérieur, ain de réduire le risque d’interférences
nocives aux systèmes mobiles par satellite utilisant le même canal;
• Le gain d’antenne maximum autorisé pour les appareils fonctionnant dans les bandes
comprises entre 5250 et 5350MHz, et entre 5470 et 5725MHz, doit se conformer à la
limite de p.i.r.e.; et
• Le gain d’antenne maximum autorisé pour les appareils fonctionnant dans la bande
comprise entre 5 725 et 5825MHz doit se conformer aux limites de p.i.r.e. spéciiées
pour l’exploitation point à point et non point à point, selon le cas.
De plus, les utilisateurs de radars de haute puissance sont désignés comme utilisateurs
principaux (c.-à-d. comme utilisateurs prioritaires) des bandes comprises entre 5250 et
5350MHz, et entre 5650 et 5850MHz, et ces radars pourraient causer des interférences
et/ou des dommages aux appareils LAN-EL.
This equipment complies with IC RSS-102 RF exposure limits set forth for an uncontrolled
environment. This equipment should be installed and operated with minimum distance 20
cm between the radiator & your body.
Cet équipement est conforme aux limites d’exposition aux rayonnements IC établies pour
un environnement non contrôlé. Cet équipement doit être installé et utilisé avec un mini-
mum de 20 cm de distance entre la source de rayonnement et votre corps.
CE RF Exposure Compliance
This device meets the EU requirements (1999/519/EC) and the International Commission
on Non-Ionizing Radiation Protection (ICNIRP) on the limitation of exposure of the general
public to electromagnetic ields by way of health protection.
This device is restricted to indoor use only when operating in the 5150 to 5350 MHz fre-
quency range.

IMPORTANT for UK Power Adapter Cord
If the available socket outlet is not suitable for the plug supplied with this equipment, it
should be cut o and an appropriate three pin plug itted. With alternative plugs on ap-
proved 3 amp fuse must be itted in the plug or adaptor or in the main fuse box.
The plug severed from the mains lead must be destroyed, as a plug with bared lexible cords
is hazardous if engaged in a live socket outlet. In the event of replacing the plug fuse, use a
3 amp fuse approved by ASTA to BS 1362, i.e. carries the mark. Always replace the fuse
cover, never use plugs with the fuse cover omitted.
WARNING — THIS APPLIANCE MUST BE EARTHED.
The wires in this mains lead are coloured in accordance with the following code:
Green-and-Yellow = Earth Blue = Neutral Brown = Live
As the colour of the wiring in the mains lead of this appliance may not correspond with the
coloured markings identifying the terminals in your plug, proceed as follows:
• The wire which is coloured Green-and-Yellow must be connected to the terminal in the plug
which is marked with the letter “E”, or by the earth symbol or coloured Green-and-Yellow.
• The wire which is coloured Blue must be connected to the terminal which is marked with
the letter “N” or coloured Black or Blue.
• The wire which is coloured Brown must be connected to the terminal which is marked
with the letter “L” or coloured Red or Brown.
Argentina
Este producto utiliza para su funcionamiento
una fuente de alimentación, modelo FSP040-RHBN3
marca Clover con las siguientes características
técnicas: Entrada: AC 100-240 V, 50-60 Hz, 1.5 A, Cl. I;
Salida: DC 12 V, 3.33 A, que ha sido certiicada para su
utilización en el mercado argentino.
Conectar una fuente
diferente a la provista podría
ocasionar un incendio o
choque eléctrico. No utilice
una fuente diferente a la
provista con el equipo.

EU Declaration of Conformity
Hereby, Clover Network, LLC declares that the radio equipment type, C305 is in compliance
with Directive 2014/53/EU. The full text of the EU declaration of conformity is available at the
following internet address:
eu.clover.com/eu-compliance
The frequency band and the maximum transmitted power in EU are listed below:
2400MHz – 2483.5MHz: 20 dBm (EIRP)
5150MHz – 5250MHz: 23 dBm (EIRP)
5250MHz – 5350MHz: 23 dBm (EIRP)
5470MHz – 5725MHz: 23 dBm (EIRP)
LTE Band 1: 23dBm (conducted)
LTE Band 3: 23dBm (conducted)
LTE Band 7: 23dBm (conducted)
LTE Band 8: 23dBm (conducted)
LTE Band 20: 23dBm (conducted)
NFC (13.56MHz): -1.43 dBμA/m (@10m)
NOTE: 5150MHz-5350MHz is for indoor use only.
Caution: Exposure to Radio Frequency Radiation
This equipment complies with EU radiation exposure limits set forth for an uncontrolled en-
vironment. This equipment should be installed and operated with minimum distance 20cm
between the radiator & your body.

Clover Mini 3
Model Number: C305
Patent
clover.com/patents
Clover Network, LLC
415 N Mathilda Ave
Sunnyvale, CA 94085, USA
EU Importer: Marketplace
Merchant Solutions Ltd
Unit 9, Richview Oice Park
Clonskeagh, Dublin 14, Ireland
Waste Electrical and Electronic Equipment-WEEE
NOTE: This product is covered electronic equipment under the European Union’s Waste
from Electrical and Electronic Equipment (“WEEE”) Directive (2012/19/EU). The WEEE
Directive requires that covered equipment be collected and managed separately from
typical household waste in all EU member states. Please follow the guidance of your local
environmental authority or ask the shop where you purchased the product for collection or
recycling options.
v6